Chemical Engineering / Kimya Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/14
Browse
3 results
Search Results
Article Citation - WoS: 20Citation - Scopus: 24Preparation of Monodisperse Silica Spheres and Determination of Their Densification Behaviour(Elsevier Ltd., 2014) Topuz, Berna; Şimşek, Deniz; Çiftçioğlu, MuhsinMonodisperse silica spheres in the 50-520 nm size range were prepared by using the Stober process. Diffusive growth has been determined from Nielsen chronomal analysis for the 520 and 310 nm monodisperse silica spheres. The densification behaviour and evolution of the microstructure of the sphere compacts indicated an inverse dependence of shrinkage rate on the sphere size due to viscous sintering. The increase in sphere size from 50 to 500 nm shifted the densification temperature from ∼ 1120 °C to 1240 °C. The amorphous nature of the spheres was conserved up to 1200 °C where cristobalite crystal nucleation started and complete transformation to cristobalite phase has been observed upon heat treatment at 1300 °C. The activation energies for viscous sintering according to the Frenkel and Mackenzie/Shuttleworth models were calculated as 125 and 335 kJ/mol, respectively. These substantially low activation energies can be attributed to the presence of a significant level of silanol groups.Conference Object Investigation of Ha Cement Preparation and Properties by Using Central Composite Design(Trans Tech Publications, 2012) Çetin, Ali Emrah; Şimşek, Deniz; Çiftçioğlu, Muhsin; Akdeniz, Yelda; Özmıhçı, Filiz; Aykut Yetkiner, ArzuThe goal of the present work was to investigate the effects of several cement preparation parameters on setting and hardening reaction mechanisms and hydroxyapatite (HA) cement properties. A central composite experimental design (CCD) was conducted by choosing particle size, solid to liquid ratio, pH, seed concentration and buffer concentration as design parameters along with compressive strength and setting time being the responses. Tetracalcium phosphate (TTCP) powders were prepared by heat treatment of calcium and phosphate source mixtures in the 1200-1400°C temperature range followed by quenching to room temperature in a dessicator. The second phase used in the formulations (brushite) was prepared by aqueous chemical methods. A series of HA pastes/cements were prepared by changing the above mentioned design parameters. Cements were characterized by a standardized setting time test, mechanical testing machine, SEM and XRD. HA cements with the desired properties can be formulated by using CCD in which the responses were expressed by a second order polynomial equation of the parameters. Compressive strengths for the majority of HA cements were determined to be in the 100-160 MPa range which is significantly higher than those reported in the literature. © (2012) Trans Tech Publications.Conference Object Citation - WoS: 8Citation - Scopus: 12Mechanical Properties of Hydroxyapatite Composites Reinforced With Hydroxyapatite Whiskers(Trans Tech Publications, 2004) Şimşek, Deniz; Çiftçioğlu, Rukiye; Güden, Mustafa; Çiftçioğlu, Muhsin; Harsa, Hayriye ŞebnemSintering and mechanical behavior of pure and hydroxyapatite (HA) whisker reinforced HA composites were investigated in this work. Pure and composite samples were prepared by using a commercial powder and whiskers prepared by molten salt synthesis. The dry-pressed samples were sintered in the 800 and 1300°C range. The effect of whisker-addition on the mechanical properties of HA was investigated through compression and hardness testing. Compressive strength and fracture strain were observed to increase by the addition of whiskers.