Chemical Engineering / Kimya Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/14
Browse
2 results
Search Results
Article Citation - WoS: 28Citation - Scopus: 29Development of a High-Flux Thin-Film Composite Nanofiltration Membrane With Sub-Nanometer Selectivity Using a Ph and Temperature-Responsive Pentablock Co-Polymer(American Chemical Society, 2019) Bar, Canbike; Çağlar, Nagahan; Uz, Metin; Mallapragada, Surya K.; Alsoy Altınkaya, SacideProducing block co-polymer-based nanofiltration (NF) membranes with sharp molecular weight cutoffs via an efficient method exhibiting persistent size-based separation quality is challenging. In this study, this challenge was addressed by reporting a facile approach to fabricate pentablock co-polymer (PBC)-based thin-film composite (TFC) NF membranes. The PBC, consisting of temperature-responsive Pluronic F127 (PEO-b-PPO-b-PEO) middle blocks and pH-responsive poly(N,N-(diethylamino)ethyl methacrylate) end blocks, were synthesized by atom-transfer radical polymerization. This polymer was then attached electrostatically to the surface of polysulfone/sulfonated polyether-sulfone support membranes fabricated using a non-solvent-induced phase separation technique. The conformational changes of the PBC chains in response to pH and temperature determined the, pure water flux and neutral solute (PEG 1000) rejection performance of TFC membranes. Permeability of the membranes increased from 13.0 +/- 0.63 to 15.9 +/- 0.06 L/m(2).h bar and from 6.7 +/- 0.00 to 13.9 +/- 0.07 L/m(2).h.bar by changing the solution pH from 4 to 8.5 and temperature from 4 to 25 degrees C, respectively. The pH- and temperature-responsive conformational changes did not affect the PEG 1000 rejection and membrane pore radius, which remained constant at similar to 89% and similar to 0.9 nm, respectively. This important finding was attributed to the high grafting density of co-polymer chains, resulting in spatial limitations among the grafted chains. The pore size of similar to 0.9 nm achieved with the proposed membrane design is the smallest size reported so far for membranes fabricated from block copolymers. TFC membranes demonstrated high stability and maintained their flux and rejection values under both static (storage in an acidic solution for up to 1 month) and dynamic (filtering PEG 1000 solution over 1 week) conditions. Pentablock copolymers enable a NF membrane with a sharp molecular weight cutoff suitable for size-selective separations. The membrane fabrication technique proposed in this study is a scalable and promising alternative that does not involve complex synthetic routes.Article Citation - WoS: 51Citation - Scopus: 57Characterization of Waterborne Acrylic Based Paint Films and Measurement of Their Water Vapor Permeabilities(Elsevier, 2006) Topçuoğlu, Özge; Alsoy Altınkaya, Sacide; Balköse, DevrimRecently, production of waterborne coatings has increased significantly as a consequence of strict pollution regulations. Waterborne coatings are sensitive to humidity, thus, their barrier properties with respect to permeation of moisture needs to be determined. Among various coating constituents, binder represents the matrix structure and its amount relative to the amounts of pigments and fillers can significantly affect the structure, hence the barrier property of the coating. In this study, waterborne acrylic based paints applied as protective coating on interior and exterior wall of the buildings are studied. The paint samples formulated with four different binder contents by a commercial paint company are used in the experiments. We first determine unknown ingredients of the paint samples using different characterization tools and then investigate the effect of the binder content on the structure of the paint films. In addition, water vapor permeability of the paint films is measured using a permeation cell. Results show that the barrier property of the waterborne acrylic based paint films against humidity decreases with decreased binder content due to uneven distribution of the pigments, consequently, porous structure formation in the films.