Chemical Engineering / Kimya Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/14
Browse
2 results
Search Results
Article Methylene Blue Removal of Fixed-Bed Column Reactor With Pumice and Nzvi-Pumice: Experimental and Modeling Study(Süleyman Demirel Üniversitesi, 2019) Genişoğlu, Mesut; Gören, Ayşegül Yağmur; Balcı, Esin; Recepoğlu, Yaşar Kemal; Ökten, Hatice EserNano zero-valent iron (nZVI) emerges as a low cost and eco-friendly adsorbent to treat textile wastewater, which is rich in dye content. However nZVI particles can easily agglomerate in aqueous environment due to electrostatic interaction, decreasing their treatment efficiency. Therefore pumice, a low-cost and naturally found porous material with lower specific surface area (2m2/gr), can be used as support material to reduce agglomeration of nZVI. Treatment efficiencies of pumice/nZVI packing (10:0 and 9:1 (w/w)) in column reactor for specified initial methylene blue concentrations (25, 50, 75 and 100 mg/L) were investigated in this study. Adsorption capacities of the adsorbents were calculated as 2.8 and 4.2 mg/g-adsorbent, respectively at 100 mg/L initial methylene blue concentration. Mixed bed column performed significantly better than its pumice-only counterpart for low initial concentrations. Thomas adsorption model was applied to experimental results with a moderate to high predictive power.Article Citation - WoS: 14Citation - Scopus: 15Chitosan-Immobilized Pumice for the Removal of As(v) From Waters(Springer Verlag, 2014) Turan, Dilek; Kocahakimoğlu, Cemre; Boyacı, Ezel; Sofuoğlu, Sait Cemil; Eroğlu, Ahmet EminA novel sorbent, chitosan-immobilized pumice, has been prepared for the sorption of As(V) from waters prior to its determination by hydride generation atomic absorption spectrometry. The success of the immobilization has been checked with such characterization techniques as scanning electron microscopy, thermal gravimetric analysis, and elemental analysis. Points of zero charge of the sorbents were determined with potentiometric mass titration. Batch-type equilibration studies have shown that the novel sorbent can be employed at a wide pH range resulting in quantitative sorption (>90 %) at pH 3.0-7.0 and greater than 70 % sorption at pH >8.0. These results demonstrate the advantage of immobilizing chitosan onto pumice, because, under the same conditions, pumice displays <20 % sorption toward As(V), whereas chitosan gives approximately 90%sorption only at pH 3.0. The validity of the method was verified through the analysis of ultrapure, bottled drinking, and tap water samples spiked with arsenate; the respective sorption percentages of 93.2 (±0.7), 89.0 (±1.0), and 80.9 (±1.3) were obtained by batch-type equilibration. Arsenic sorption was also examined in the presence of common interfering ions resulting in competing effects of PO3- 4 and NO- 3on As(V) adsorption.