Materials Science and Engineering / Malzeme Bilimi ve Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4719
Browse
4 results
Search Results
Article Citation - WoS: 3Citation - Scopus: 2Electrocaloric Behaviour of Tape Cast and Grain Oriented Nbt-Kbt Ceramics(Elsevier Sci Ltd, 2024) Unal, Muhammet Ali; Karakaya, Merve; Irmak, Tugce; Yildirim-Ozarslan, Gokce; Avci, A. Murat; Fulanovic, Lovro; Adem, UmutWe have investigated the effects of grain orientation and tape casting process on the electrocaloric properties of 0.82Na(0.5)Bi(0.5)TiO(3)-0.18 K0.5Bi0.5TiO3 (0.82NBT-0.18KBT) ceramics at the Morphotropic Phase Boundary (MPB), using direct and indirect measurements. We observe a larger electrocaloric response for the template-free ceramics compared to 7 and 10 wt% template containing ones, suggesting that grain orientation along rhombohedral < 100 > does not improve the electrocaloric response. Indirect measurements yielded a large adiabatic temperature change of around 3 K under an electric field of 50 kV/cm, which is significantly higher than 0.9 K reached at a lower electric field of 40 kV/cm using the direct measurement.Article Citation - WoS: 11Citation - Scopus: 11Enhanced Electrocaloric Effect of P(vdf-Trfe) Nanocomposites With Ca and Sn Co-Doped Batio3 Particles(Elsevier, 2023) Tokkan, Melike; Demir, Mustafa M.; Adem, UmutWe report on the enhancemenent of electrocaloric effect in solution cast polymer nanocomposites based on Poly (vinylidene fluoride-co-trifluoroethylene) [P(VDF-TrFE) 55-45] with Ca and Sn co-substituted BaTiO3 ceramic fillers (Ba0.94Ca0.06Ti0.925Sn0.075O3, BCST). Saturated hysteresis loops and normal ferroelectric behaviour of the copolymer-based nanocomposites-as opposed to the relaxor ferroelectric nature of the terpolymer-based ones-allow the utilization of the indirect method to estimate the electrocaloric properties. Both the dielectric constant and electrocaloric temperature change (AT) increases as the particle content increases. Maximum adiabatic temperature change was obtained as 6.96 K under 900 kV/cm for the 10 vol % BCST containing polymer composite around the Curie temperature of the copolymer (70 degrees C). This relatively large electrocaloric strength is slightly lower than those obtained for terpolymer-based nanocomposites.Article Citation - WoS: 13Citation - Scopus: 16Electrocaloric Properties of Ba0. 8sr0. 2ti1-Xzrxo3 (0? X? 0.1) System: the Balance Between the Nature of the Phase Transition and Phase Coexistence(Elsevier Ltd., 2020) Şanlı, Keriman; Adem, UmutWe investigate the electrocaloric effect of Ba0.8Sr0.2Ti1-xZrxO3 (0 ≤ x ≤ 0.1) system by comparing the electrocaloric temperature change (ΔT) of different compositions belonging to the different regions of the phase diagram. We show that as the amount of Zr increases, electrocaloric temperature change initially decreases as the phase transition gets diffuse then increases again as the composition of the samples are located closer to the critical point where different ferroelectric phases coexist. Since the critical point is reached at relatively low Zr substitution levels (i.e. around x = 0.07), the phase transition doesn't get too diffuse and thefore the compositions between x = 0 and x = 0.10 (which contains higher Zr than the critical point composition) have comparable ΔT values. Electrocaloric efficiency of these compositions (x = 0.03, 0.05 and 0.07) is around 0.20 K mm/kV at 20 kV/cm. We discuss the results in terms of the balance between the nature of the phase transition and proximity to the critical point, based on the phase diagram.Article Citation - WoS: 33Citation - Scopus: 33Influence of Aging on Electrocaloric Effect in Li+ Doped Batio3 Ceramics(Elsevier Ltd., 2019) Güvenç, Çetin Meriç; Adem, UmutAging creates significant changes in the properties of the ferroelectric materials such as dielectric and piezoelectric properties. However, the influence of aging on the electrocaloric effect (ECE) has not yet been investigated. In this work, we investigate the effect of the aging on the ECE in acceptor (Liþ) doped BaTiO3 ceramics. We observe that aging induced defect polarization (PD) reduces the saturation polarization of the doped samples until Tc ¼ 115 C. Above that temperature PD loses its effectiveness and material behaves like a fresh sample. Suppression of polarization below TC due to aging effect results in a sharper slope change in the temperature dependence of electrical polarization in aged samples which causes an increase in the electrocaloric temperature change of Liþ doped BaTiO3 ceramics up to 23% at TC. Above a critical Li doping amount, both negative and positive electrocaloric effect are observed in the same sample.