Materials Science and Engineering / Malzeme Bilimi ve Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4719
Browse
11 results
Search Results
Now showing 1 - 10 of 11
Article Citation - WoS: 15Citation - Scopus: 16Monitoring the Crystal Orientation of Black-Arsenic Via Vibrational Spectra(Royal Society of Chemistry, 2019) Kandemir, Ali; İyikanat, Fadıl; Şahin, HasanIn this study, the structural, mechanical, and vibrational properties of a recently discovered anisotropic ultra-thin material, black-arsenic (b-As), are investigated by using density functional theory. Direction dependent elastic constants such as in-plane stiffness, Young's modulus and Poisson's ratio of single-layer b-As are calculated and compared with those of the structural cousin black-phosphorus (b-P). The calculated Poisson's ratio of b-As for the zigzag direction is nearly 1, which is quite higher than that of b-P, 0.65. Besides, it is found that all the three elastic constants are highly anisotropic and their values in the zigzag direction are almost three times higher than that of the armchair direction. The mechanical strength of the material is also calculated and high-toughness is seen in both armchair and zigzag directions. It is revealed that the material is quite stiff against straining along the zigzag direction; in contrast, it is quite flexible along the armchair direction. Vibrational stability analysis shows that the material is stable up to 9% biaxially applied strain, and 12% and 45% uniaxially applied strain in the zigzag and armchair directions, respectively. Furthermore, the prominent Raman active peaks of the b-As structure show strong anisotropy in the strain dependent vibrational spectra and they can also be used for easy-determination of the crystal orientation of b-As from Raman measurements.Article Citation - WoS: 93Citation - Scopus: 95Single-Layer Janus-Type Platinum Dichalcogenides and Their Heterostructures(American Chemical Society, 2019) Kahraman, Zeynep; Kandemir, Ali; Yağmurcukardeş, Mehmet; Şahin, HasanUltrathin two-dimensional Janus-type platinum dichalcogenide crystals formed by two different atoms at opposite surfaces are investigated by performing state-of-the-art density functional theory calculations. First, it is shown that single-layer PtX2 structures (where X = S, Se, or Te) crystallize into the dynamically stable IT phase and are indirect band gap semiconductors. It is also found that the substitutional chalcogen doping in all PtX2 structures is favorable via replacement of surface atoms with a smaller chalcogen atom, and such a process leads to the formation of Janus-type platinum dichalcogenides (XPtY, where X and Y stand for S, Se, or Te) which are novel single-layer crystals. While all Janus structures are indirect band gap semiconductors as their binary analogues, their Raman spectra show distinctive features that stem from the broken out-of-plane symmetry. In addition, it is revealed that the construction of Janus crystals enhances the piezoelectric constants of PtX2 crystals significantly both in the in plane and in the out-of-plane directions. Moreover, it is shown that vertically stacked van der Waals heterostructures of binary and ternary (Janus) platinum dichalcogenides offer a wide range of electronic features by forming bilayer heterojunctions of type-I, type-II, and type-III, respectively. Our findings reveal that Janus-type ultrathin platinum dichalcogenide crystals are quite promising materials for optoelectronic device applications.Article Citation - WoS: 3Citation - Scopus: 3Monolayer Aste2: Stable Robust Metal in 2d, 1d and 0d(Wiley, 2018) Badalov, S. V.; Kandemir, Ali; Şahin, HasanThe structural, phononic, and electronic properties of the monolayer structures of AsTe2 are characterized by performing density functional theory (DFT) calculations. Total energy optimization and phonon calculations reveal that single layers of the 2H-AsTe2 and 1T-AsTe2 phases form dynamically stable crystal structures. Electronic structure analysis also shows that both 2H and 1T phases have nonmagnetic metallic character. It is also predicted that the metallic nature of the ultra-thin both 2H-AsTe2 and 1T-AsTe2 structures remain unchanged even under high biaxial strain values. For further examination of the dimensionality effect in the robust metallicity in 2D AsTe2 phases, electronic characteristics of 1D nanoribbons and 0D quantum dots are also investigated. It is found that independent from the dimension and crystallographic orientations 0D and 1D structures of 2H- and 1T-AsTe2 structures have metallic behavior. It is found that single layers of AsTe2 are quite promising materials for nanodevice applications owing to the robust metallic character.Article Citation - WoS: 171Citation - Scopus: 169Janus Single Layers of In2sse: a First-Principles Study(American Physical Society, 2018) Kandemir, Ali; Şahin, HasanBy performing first-principles calculations, we propose a stable direct band gap semiconductor Janus single-layer structure, In2SSe. The binary analogs of the Janus structure, InS and InSe single layers are reviewed to evince the structural and electronic relation with In2SSe. The structural optimization calculations reveal that a Janus In2SSe single layer has hexagonal geometry like the InS and InSe single layers, which are also its structural analogs. The Janus single layer is dynamically stable, as indicated by the phonon spectrum. The electronic band diagram of the Janus structure shows that an In2SSe single layer is a direct band gap semiconductor, in contrast to its analogs, InS and InSe single layers, which are indirect band gap semiconductors. Nevertheless, it is found that the strain effect on electronic properties of the InS and InSe single layers designates the electronic structure of the Janus single layer. A rough model for the construction of the electronic band diagram of the Janus structures is discussed, and it is indicated that the difference in work functions of chalcogenide sides in the Janus structure determines the construction of the electronic structure. It is found that the Janus structure is a robust direct gap semiconductor under tolerable strain; for that reason, the Janus In2SSe single layer is a candidate for optoelectronic nanodevice applications.Article Citation - WoS: 67Citation - Scopus: 66Bilayers of Janus Wsse: Monitoring the Stacking Type: Via the Vibrational Spectrum(Royal Society of Chemistry, 2018) Kandemir, Ali; Şahin, HasanMotivated by the recent successful synthesis of Janus type single layers of transition metal dichalcogenides, we investigate the stability, vibrational and electronic properties of the Janus single layer structure of WSSe and its bilayers by means of density functional theory. The structural and vibrational analysis show that the Janus single layer of WSSe forms a dynamically stable structure in the 2H phase. Owing to its non-centrosymmetric structure, the Janus WSSe single layer has two in-plane (E) and two out-of-plane (A) Raman active phonon modes. The eigen-frequencies of the prominent Raman active modes are calculated to be 277 (A) and 322 (E) cm-1. Similar to single layer WS2 and WSe2, Janus WSSe is a direct band gap semiconductor that has two electronically different faces. In addition, the possible bilayer stacking orders of the Janus WSSe single layers are investigated. It is found that there are 3 stacking types of bilayer Janus WSSe and each stacking type has distinctive Raman characteristics in its vibrational spectrum. Our results show that thanks to the vibrational characteristics, which stem from the distinctive interlayer interactions at different sides, the stability and stacking types of the bilayer of WSSe Janus structure can be monitored.Article Citation - WoS: 21Citation - Scopus: 27Increasing Solubility of Metal Silicates by Mixed Polymeric Antiscalants(Elsevier Ltd., 2019) Topçu, Gökhan; Çelik, Aslı; Kandemir, Ali; Baba, Alper; Şahin, Hasan; Demir, Mustafa MuammerThe increase of silicate solubility is a big challenge for both hot and cold water because it reduces the deposition of metal silicates frequently observed in such systems and causes operational obstacles. The deposition of silicate coats the inner surface of the pipelines in an uncontrolled manner and reduces the harvesting of energy from brines. In this work, the solubility performance of two commercial water-soluble polymeric agents (poly(ethylene glycol) (PEG) and poly(vinyl alcohol) (PVA)) of various molecular weights employing dosage from 25 to 100 mg/L was examined. Along with dispersant-type antiscalant, poly(acrylamide) (PAM), poly(vinylsulfonic acid, sodium salt) (PVSA), and poly(vinylphosphonic acid) (PVPA) having chelating acidic groups were employed. Metal silicate deposits were obtained artificially in the lab-scale pressurized reactor. The experimental conditions employed were quite similar to a model power plant located in Çanakkale, Turkey. The concentration of dissolved silica was increased from 130 to 420 mg/L when 100 mg/L PEG 1500 and 25 mg/L PVSA were employed as a mixture. For the atomic-level understanding of the interaction of chelating groups with metal cations, DFT calculations were performed too.Article Citation - WoS: 110Citation - Scopus: 109Structural, Electronic and Phononic Properties of Ptse2: From Monolayer To Bulk(IOP Publishing Ltd., 2018) Kandemir, Ali; Akbalı, Barış; Kahraman, Z.; Badalov, S. V.; Özcan, Mehmet; İyikanat, Fadıl; Şahin, HasanThe layer dependent structural, electronic and vibrational properties of the 1T phase of two dimensional (2D) platinum diselenide are investigated by means of state-of-the-art first-principles calculations. The main findings of the study are: (i) monolayer platinum diselenide has a dynamically stable 2D octahedral structure with 1.66 eV indirect band gap, (ii) the semiconducting nature of 1T-PtSe2 monolayers remains unaffected even at high biaxial strains, (iii) top-to-top (AA) arrangement is found to be energetically the most favorable stacking of 1T-PtSe2 layers, (iv) the lattice constant (layer-layer distance) increases (decreases) with increasing number of layers, (v) while monolayer and bilayer 1T-PtSe2 are indirect semiconductors, bulk and few-layered 1T-PtSe2 are metals, (vi) Raman intensity and peak positions of the A1g and Eg modes are found to be highly dependent on the layer thickness of the material, hence; the number of layers of the material can be determined via Raman measurements.Article Citation - WoS: 7Citation - Scopus: 8Hydrogenation-driven phase transition in single-layer TiSe2(IOP Publishing Ltd., 2017) İyikanat, Fadıl; Kandemir, Ali; Özaydın, H. Duygu; Senger, Ramazan Tuğrul; Şahin, HasanFirst-principles calculations based on density-functional theory are used to investigate the effects of hydrogenation on the structural, vibrational, thermal and electronic properties of the charge density wave (CDW) phase of single-layer TiSe2. It is found that hydrogenation of single-layer TiSe2 is possible through adsorption of a H atom on each Se site. Our total energy and phonon calculations reveal that a structural phase transition occurs from the CDW phase to the T d phase upon full hydrogenation. Fully hydrogenated TiSe2 presents a direct gap semiconducting behavior with a band gap of 119 meV. Full hydrogenation also leads to a significant decrease in the heat capacity of single-layer TiSe2.Article Citation - WoS: 8Citation - Scopus: 10Stability, Electronic and Phononic Properties of Ss and 1t Structures of Sitex (x = 1, 2) and Their Vertical Heterostructures(IOP Publishing Ltd., 2017) Kandemir, Ali; İyikanat, Fadıl; Şahin, HasanBy performing first-principles calculations, we predict a novel, stable single layer phase of silicon ditelluride, 1T-SiTe2, and its possible vertical heterostructures with single layer β-SiTe. Structural optimization and phonon calculations reveal that 1T-SiTe2 structure has a dynamically stable ground state. Further analysis of the vibrational spectrum at the - point shows that single layer 1T-SiTe2 has characteristic phonon modes at 80, 149, 191 and 294 cm-1. Electronic-band structure demonstrates that 1T-SiTe2 phase exhibits a nonmagnetic metallic ground state with a negligible intrinsic spinorbit splitting. Moreover, it is shown that similar structural parameters of 1T-SiTe2 and existing β-SiTe phases allows construction of 1T-β heterostructures with a negligible lattice mismatch. In this regard, it is found that two energetically favorable stacking orders, namely AA and ATB, have distinctive shear and layer breathing phonon modes. It is important to note that the combination of semiconducting β-SiTe and metallic 1T-SiTe2 building blocks forms ultra-thin Schottky barriers that can be used in nanoscale optoelectronic device technologies.Article Citation - WoS: 3Citation - Scopus: 2?-Silicene as Oxidation-Resistant Ultra-Thin Coating Material(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2017) Kandemir, Ali; İyikanat, Fadıl; Bacaksız, Cihan; Şahin, HasanBy performing density functional theory (DFT)-based calculations, the performance of a-silicene as oxidation-resistant coating on Ag(111) surface is investigated. First of all, it is shown that the Ag(111) surface is quite reactive against O atoms and O2 molecules. It is known that when single-layer silicene is formed on the Ag(111) surface, the 3 × 3-reconstructed phase, a-silicene, is the ground state. Our investigation reveals that as a coating layer, a-silicene (i) strongly absorbs single O atoms and (ii) absorbs O2 molecules by breaking the strong O-O bond. (iii) Even the hollow sites, which are found to be most favorable penetration path for oxygens, serves as high-energy oxidation barrier, and (iv) α-silicene becomes more protective and less permeable in the presence of absorbed O atom. It appears that single-layer silicene is a quite promising material for ultra-thin oxidation-protective coating applications.