Materials Science and Engineering / Malzeme Bilimi ve Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4719
Browse
11 results
Search Results
Now showing 1 - 10 of 11
Article Citation - WoS: 3Citation - Scopus: 3Green Fabrication of Lanthanide-Doped Hydroxide-Based Phosphors: Y(oh)(3):eu3+ Nanoparticles for White Light Generation(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2019) Güner, Tuğrul; Kuş, Anılcan; Özcan, Mehmet; Genç, Aziz; Şahin, Hasan; Demir, Mustafa MuammerPhosphors can serve as color conversion layers to generate white light with varying optical features, including color rendering index (CRI), high correlated color temperature (CCT), and luminous efficacy. However, they are typically produced under harsh synthesis conditions such as high temperature, high pressure, and/or by employing a large amount of solvent. In this work, a facile, water-based, rapid method has been proposed to fabricate lanthanide-doped hydroxide-based phosphors. In this sense, sub-micrometer-sized Y(OH)(3):Eu3+ particles (as red phosphor) were synthesized in water at ambient conditions in <= 60 min reaction time. The doping ratio was controlled from 2.5-20 mol %. Additionally, first principle calculations were performed on Y(OH)(3):Eu3+ to understand the preferable doping scenario and its optoelectronic properties. As an application, these fabricated red phosphors were integrated into a PDMS/YAG:Ce3+ composite and used to generate white light. The resulting white light showed a remarkable improvement (approximate to 24%) in terms of luminous efficiency, a slight reduction of CCT (from 3900 to 3600 K), and an unchanged CRI (approximate to 60) as the amount of Y(OH)(3):Eu3+ was increased.Article Citation - WoS: 3Citation - Scopus: 4Experimental and First-Principles Investigation of Cr-Driven Color Change in Cesium Lead Halide Perovskites(American Institute of Physics, 2019) Özen, Sercan; Güner, Tuğrul; Topçu, Gökhan; Özcan, Mehmet; Demir, Mustafa Muammer; Şahin, HasanHerein, we report room temperature Cr-doping for all-inorganic perovskites that have attracted great attention in recent years due to their extraordinary optical properties, low cost, and ease of synthesis. Incorporation of Cr 3 + ions into the perovskite crystal lattices is achieved by following a facile route involving an antisolvent recrystallization method at room temperature. It is shown that both Cr-doping and formation of crystals in the CsPbBr x Cl 3 - x phase are provided by increasing the concentration of the CrCl 3 solution. It is also observed that the doping procedure leads to the emergence of three types of distinctive peaks in the PL spectrum originating from CsPbBr x Cl 3 - x domains (476-427nm), Cr-strained host lattices (515nm), and midgap states formed by Cr dopants (675-775nm). It is also found that the Cr-doped perovskites emitting a dark violaceous color change their color to white with a high color rendering index (88) in 30-day time intervals. Easy-tunable optical properties of all-inorganic Cs perovskites indicate their great potential for future optoelectronic device applications.Article Citation - WoS: 93Citation - Scopus: 95Single-Layer Janus-Type Platinum Dichalcogenides and Their Heterostructures(American Chemical Society, 2019) Kahraman, Zeynep; Kandemir, Ali; Yağmurcukardeş, Mehmet; Şahin, HasanUltrathin two-dimensional Janus-type platinum dichalcogenide crystals formed by two different atoms at opposite surfaces are investigated by performing state-of-the-art density functional theory calculations. First, it is shown that single-layer PtX2 structures (where X = S, Se, or Te) crystallize into the dynamically stable IT phase and are indirect band gap semiconductors. It is also found that the substitutional chalcogen doping in all PtX2 structures is favorable via replacement of surface atoms with a smaller chalcogen atom, and such a process leads to the formation of Janus-type platinum dichalcogenides (XPtY, where X and Y stand for S, Se, or Te) which are novel single-layer crystals. While all Janus structures are indirect band gap semiconductors as their binary analogues, their Raman spectra show distinctive features that stem from the broken out-of-plane symmetry. In addition, it is revealed that the construction of Janus crystals enhances the piezoelectric constants of PtX2 crystals significantly both in the in plane and in the out-of-plane directions. Moreover, it is shown that vertically stacked van der Waals heterostructures of binary and ternary (Janus) platinum dichalcogenides offer a wide range of electronic features by forming bilayer heterojunctions of type-I, type-II, and type-III, respectively. Our findings reveal that Janus-type ultrathin platinum dichalcogenide crystals are quite promising materials for optoelectronic device applications.Article Citation - WoS: 72Citation - Scopus: 77Gd3+-Doped Alpha-Cspbi3 Nanocrystals With Better Phase Stability and Optical Properties(American Chemical Society, 2019) Güvenç, Çetin Meriç; Yalçınkaya, Yenal; Özen, Sercan; Şahin, Hasan; Demir, Mustafa MuammerBlack alpha-CsPbI3 perovskites are unable to maintain their phase stability under room conditions; hence, the alpha-CsPbI3 phase transforms into a thermodynamically stable yellow delta-CsPbI3 phase within a few days, which has a nonperovskite structure and high band gap for optoelectronic applications. This phase transformation should be prevented or at least retarded to make use of superior properties of alpha-CsPbI3 in optoelectronic applications. In this study, Gd3+ doping was employed with the aim of increasing the stability of alpha-CsPbI3. All doped alpha-CsPbI3 nanocrystals with various levels of Gd3+, between 5 and 15 mol %, have shown greater phase stability than that of the pure alpha-CsPbI3 phase from 5 days up to 11 days under ambient conditions. This prolonged phase stability can be attributed to three potential reasons: increased tolerance factor of the perovskite structure, distorted cubic symmetry, and decreased defect density in nanocrystals. Urbach energy values suggest the reduction of defect density in the doped nanocrystals. Also, use of 10 mol % Gd3+ as a dopant material increases the photoluminescence quantum yield from 70 to 80% and fluorescence lifetime of alpha-CsPbI3 from 47.4 to 64.4 ns. Further, density functional theory calculations are in a good agreement with the experimental results.Article Citation - WoS: 3Citation - Scopus: 3Monolayer Aste2: Stable Robust Metal in 2d, 1d and 0d(Wiley, 2018) Badalov, S. V.; Kandemir, Ali; Şahin, HasanThe structural, phononic, and electronic properties of the monolayer structures of AsTe2 are characterized by performing density functional theory (DFT) calculations. Total energy optimization and phonon calculations reveal that single layers of the 2H-AsTe2 and 1T-AsTe2 phases form dynamically stable crystal structures. Electronic structure analysis also shows that both 2H and 1T phases have nonmagnetic metallic character. It is also predicted that the metallic nature of the ultra-thin both 2H-AsTe2 and 1T-AsTe2 structures remain unchanged even under high biaxial strain values. For further examination of the dimensionality effect in the robust metallicity in 2D AsTe2 phases, electronic characteristics of 1D nanoribbons and 0D quantum dots are also investigated. It is found that independent from the dimension and crystallographic orientations 0D and 1D structures of 2H- and 1T-AsTe2 structures have metallic behavior. It is found that single layers of AsTe2 are quite promising materials for nanodevice applications owing to the robust metallic character.Article Citation - WoS: 17Citation - Scopus: 17Monitoring the Doping and Diffusion Characteristics of Mn Dopants in Cesium Lead Halide Perovskites(American Chemical Society, 2018) Güner, Tuğrul; Akbalı, Barış; Özcan, Mehmet; Topçu, Gökhan; Demir, Mustafa Muammer; Şahin, HasanCesium lead perovskites, in the form of CsPbX3 or Cs4PbX6, have been widely used for various optoelectronic applications due to their exceptionally good optical properties. In this study, the effect of Mn doping on the structural and optical properties of cesium lead halide perovskite crystals are investigated from both experimental and theoretical points of view. It is found that adding MnCl2 during the synthesis not only leads to a Mn-driven structural phase transition from Cs4PbBr6 to CsPbCl3 but also triggers the Br- to Cl- halide exchange. On the other hand, it is observed that, under UV illumination, the color of Mn-doped crystals changes from orange to blue in approximately 195 h. While the intensity of Mn-originated photoluminescence emission exponentially decays in time, the intensity of CsPbCl3-originated emission remains unchanged. In addition, diffusive motion of Mn ions results in both a growing population of MnO2 at the surface and transition of the host into a cesium-rich Cs4PbCl6 phase.Article Citation - WoS: 110Citation - Scopus: 109Structural, Electronic and Phononic Properties of Ptse2: From Monolayer To Bulk(IOP Publishing Ltd., 2018) Kandemir, Ali; Akbalı, Barış; Kahraman, Z.; Badalov, S. V.; Özcan, Mehmet; İyikanat, Fadıl; Şahin, HasanThe layer dependent structural, electronic and vibrational properties of the 1T phase of two dimensional (2D) platinum diselenide are investigated by means of state-of-the-art first-principles calculations. The main findings of the study are: (i) monolayer platinum diselenide has a dynamically stable 2D octahedral structure with 1.66 eV indirect band gap, (ii) the semiconducting nature of 1T-PtSe2 monolayers remains unaffected even at high biaxial strains, (iii) top-to-top (AA) arrangement is found to be energetically the most favorable stacking of 1T-PtSe2 layers, (iv) the lattice constant (layer-layer distance) increases (decreases) with increasing number of layers, (v) while monolayer and bilayer 1T-PtSe2 are indirect semiconductors, bulk and few-layered 1T-PtSe2 are metals, (vi) Raman intensity and peak positions of the A1g and Eg modes are found to be highly dependent on the layer thickness of the material, hence; the number of layers of the material can be determined via Raman measurements.Article Citation - WoS: 12Citation - Scopus: 11Theoretical and Experimental Investigation of Conjugation of 1,6-Hexanedithiol on Mos2(IOP Publishing Ltd., 2018) Gül, Aytaç; Bacaksız, Cihan; Ünsal, Emre; Akbalı, Barış; Tomak, Aysel; Zareie, Hadi M.; Şahin, HasanWe report an experimental and theoretical investigation of conjugation of 1,6-Hexaneditihiol (HDT) on MoS2 which is prepared by mixing MoS2 structure and HDT molecules in proper solvent. Raman spectra and the calculated phonon bands reveal that the HDT molecules bind covalently to MoS2. Surface morphology of MoS2/HDT structure is changed upon conjugation of HDT on MoS2 and characterized by using Scanning Electron Microscope (SEM). Density Functional Theory (DFT) based calculations show that HOMO-LUMO band gap of HDT is altered after the conjugation and two-S binding (handle-like) configuration is energetically most favorable among three different structures. This study displays that the facile thiol functionalization process of MoS2 is promising strategy for obtaining solution processable MoS2.Article Citation - WoS: 8Citation - Scopus: 10Stability, Electronic and Phononic Properties of Ss and 1t Structures of Sitex (x = 1, 2) and Their Vertical Heterostructures(IOP Publishing Ltd., 2017) Kandemir, Ali; İyikanat, Fadıl; Şahin, HasanBy performing first-principles calculations, we predict a novel, stable single layer phase of silicon ditelluride, 1T-SiTe2, and its possible vertical heterostructures with single layer β-SiTe. Structural optimization and phonon calculations reveal that 1T-SiTe2 structure has a dynamically stable ground state. Further analysis of the vibrational spectrum at the - point shows that single layer 1T-SiTe2 has characteristic phonon modes at 80, 149, 191 and 294 cm-1. Electronic-band structure demonstrates that 1T-SiTe2 phase exhibits a nonmagnetic metallic ground state with a negligible intrinsic spinorbit splitting. Moreover, it is shown that similar structural parameters of 1T-SiTe2 and existing β-SiTe phases allows construction of 1T-β heterostructures with a negligible lattice mismatch. In this regard, it is found that two energetically favorable stacking orders, namely AA and ATB, have distinctive shear and layer breathing phonon modes. It is important to note that the combination of semiconducting β-SiTe and metallic 1T-SiTe2 building blocks forms ultra-thin Schottky barriers that can be used in nanoscale optoelectronic device technologies.Article Citation - WoS: 3Citation - Scopus: 2?-Silicene as Oxidation-Resistant Ultra-Thin Coating Material(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2017) Kandemir, Ali; İyikanat, Fadıl; Bacaksız, Cihan; Şahin, HasanBy performing density functional theory (DFT)-based calculations, the performance of a-silicene as oxidation-resistant coating on Ag(111) surface is investigated. First of all, it is shown that the Ag(111) surface is quite reactive against O atoms and O2 molecules. It is known that when single-layer silicene is formed on the Ag(111) surface, the 3 × 3-reconstructed phase, a-silicene, is the ground state. Our investigation reveals that as a coating layer, a-silicene (i) strongly absorbs single O atoms and (ii) absorbs O2 molecules by breaking the strong O-O bond. (iii) Even the hollow sites, which are found to be most favorable penetration path for oxygens, serves as high-energy oxidation barrier, and (iv) α-silicene becomes more protective and less permeable in the presence of absorbed O atom. It appears that single-layer silicene is a quite promising material for ultra-thin oxidation-protective coating applications.