Energy Systems Engineering / Enerji Sistemleri Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/4752
Browse
9 results
Search Results
Article Stochastic 1-D Reactive Transport Simulations To Assess Silica and Carbonate Phases During the $co_2$ Reinjection Process in Metasediments(TÜBİTAK - Türkiye Bilimsel ve Teknolojik Araştırma Kurumu, 2024) Erol, SelçukOne proposed method to mitigate carbon emission is to mineralize the $CO_2$ in deep geothermal reservoirs while mixing the coproduced CO2 with the effluent fluid for reinjection. The injection fluid temperature fluctuates due to the mixing process between CO2-charged water and the effluent fluid, and compressor interruptions change the thermodynamic conditions that influence the fluid- rock interaction in the reservoir. Mineral dissolution or precipitations are associated with changes in permeability and porosity that affect the flow and, eventually, the lifespan of the reservoir. A combined stochastic–reactive transport simulation approach is useful for inspection purposes. Moreover, the stochastic algorithm validates the deterministic reactive transport simulation and demonstrates the time evolution of a chemically reacting system in the reservoir. This study examines a range of injection temperatures between 80 °C and 120 °C to evaluate silica and calcite precipitation along a flow path. One-dimensional (1-D) reactive transport and compartment- based stochastic reaction-diffusion-advection Gillespie algorithms are carried out. The 1-D model represents a reservoir feed zone of around 2300 m. Two common metasediment rock types are evaluated for inspection. The first one is the muscovite schist, which has approximately 60% quartz, and the second is the quartz schist, consisting of roughly 90% quartz. The stochastic method can be applied more effectively if the chemical system is completely defined with proper reaction rates as a function of temperature. The mixing ratio of the coproduced $CO_2$ over the effluent fluid is around 0.0028. Simulation results show that $CO_2$ is partially sequestrated as calcite within the first 10 m of the entrance to the reservoir and plugs the pores completely in the muscovite schist scenario. Chalcedony and α-cristobalite precipitate as secondary minerals evenly along the flow path. $CO_2$ injection into a quartz schist layer is more appropriate for geochemical interactions below 120 °C.Article Citation - WoS: 7Citation - Scopus: 8Update for Reactive Transport Modeling of the Kızıldere Geothermal Field To Reduce Uncertainties in the Early Inspections(TÜBİTAK - Türkiye Bilimsel ve Teknolojik Araştırma Kurumu, 2023) Erol, Selçuk; Akın, Taylan; Akın, SerhatThe development of carbon capture and storage techniques has become essential to reduce and mitigating CO2 emissions to the atmosphere. CarbFix1 and CarbFix2 projects carried out in Iceland demonstrated that the emissions of waste CO2 gas from geothermal power plants can be captured and mixed with the effluent geofluid and subsequently injected back into the geothermal reservoir. This experience gained in the CarbFix projects expanded into other geothermal fields around Europe, and one of the demonstration sites is the geothermal field in Turkey, Kızıldere. This paper focuses on the results of an updated study on early field evaluations with reactive transport simulations. In the new three-dimensional numerical model, the geological formations and fault zones were updated according to the well-logs data. Based on the tracer tests performed in the field, the anisotropic permeabilities between the wells were evaluated and imposed into the model. Geofluid chemistry, mineral components, and the volume fractions used as input in the simulations are modified depending on the performed laboratory experiments on the metamorphic schists taken from the geothermal site (i.e. X-ray diffraction (XRD), energy dispersive X-ray (EDX), scanning-electron microscope (SEM), and batch reactor tests). Different thermodynamic databases such as Lawrance Livermore National Laboratory (LLNL) and Thermoddem databases were tested using PHREEQC and TOUGHREACT programs for consistency with experiments. The thermodynamic conditions and the geofluid-rock-CO2 interactions prevent the mineralization of CO2 in the reservoir. This outcome differs from CarbFix projects in terms of the carbonization process, but the CO2 injection is still reliable with solubility-trapping in a geothermal reservoir to partially mitigate the emission. Roughly, 200 kt of CO2 in 10 years can be safely injected into the geothermal reservoir. According to the new analysis, the ratio of magnesium, sodium, and potassium varies in solid solution series of feldspars and clay minerals as albite end-member and montmorillonite/illite end-members, respectively. The evaluations of solid solution reactions are relatively limited in the law of mass action approach used by PHREEQC and TOUGHREACT. © TÜBİTAK.Article Citation - WoS: 1Performance Analysis of Thermal Storage Assisted Cooling Tower With Night Cooling(Gazi Üniversitesi, 2020) Ouedraogo, Kiswendsida Elias; Toprak, KasımAs global warming and water scarcity issues continue to grow, it is essential to increase resources efficiency for air conditioners and power plants. In order to increase the efficiency, the systems need to be modified to take the advantages of the low night temperature and thermal storage tanks. In this study, the low night temperature and thermal storage tanks effects on the cooling tower is studied using TRNSYS. Using a chiller operating from 8:00 to 16:00 as a case study, hot water from the condenser is partially stored on daytime and cooled slowly during the night. The storage tank volume is optimized by considering two big tanks and five small tanks. The results show that night cooling reduces cooling water temperature by 5.8 degrees C or 21.8% while the cooling efficiency is increased by 36%. The thermal storage tanks enable to have the low continuous flow rate and help to reduce the fan power by 67.1%. On the storage side, compared to two tanks system, the tanks volume is reduced by 16.5% when 5 tanks are used. In theory this reduction can go up to 50% by increasing the number of tanks and reducing their individual size.Article Citation - WoS: 12Citation - Scopus: 13Assessment of Thermal Comfort Preferences in Mediterranean Climate a University Office Building Case(Vinca Inst Nuclear Sci, 2018) Turhan, Cihan; Gökçen Akkurt, GüldenThis study aims at evaluating the perceived thermal sensation of occupants with respect to thermal comfort standards, ASHRAE 55 and ISO 7730, for office buildings located in Mediterranean climate. A small office building in Izmir Institute of Technology Campus Area, Izmir, Turkey, was chosen as a case building and equipped with measurement devices to assess thermal comfort of occupants with respect to predicted mean vote and actual mean vote. Both objective and subjective measurements were conducted. The former included indoor and outdoor air temperature, mean radiant temperature, relative humidity and air velocity that were used for evaluating the thermal comfort of occupants. Oxygen concentration which can play an additional role in thermal comfort/discomfort, health and productivity of the office occupants, was also measured. Furthermore, occupants were subjected to a survey via a mobile application to obtain subjective measurements to calculate actual mean vote values. Based on objective and subjective measurements, the relationships among the parameters were derived by using simple regression analysis technique while a new combined mean vote correlation was also derived but this time by using multiple linear regression model. Neutral and comfort temperatures were obtained using indoor air temperature and actual mean vote values which were calculated from subjective measurements. The results showed that neutral temperature in the university office building was 20.9 degrees C whilst the comfort temperature range was between 19.4 and 22.4 degrees C for the heating season. By applying new comfort temperatures, energy consumption of the case building located in Mediterranean climate, can be reduced.Article Citation - WoS: 1Citation - Scopus: 2Feasibility of Large Scale Wind Turbines for Offshore Gas Platform Installation(AIMS Press, 2018) Bingöl, FerhatAlthough, offshore wind energy development emerged under way at the beginning of the millennium, Europe is planning to bring offshore wind energy capacity to over 11.6 GW until 2020. This is nearly 10 times todays installed offshore capacity and equal to nearly 50% of the new planned investment in the wind energy market. The North Sea and the Baltic Sea are the main investment areas due to the shallower sea depth. In this paper an approach to use old gas / oil platforms as the foundation for a wind turbine is examined. An off shore gas platform close to Istanbul Turkey with over 20 years more lifetime is taken as a real-life case, with the wind resource information extracted from the recent large-scale wind atlas study, Global Wind Atlas version 2. The study aims to combine recent offshore economical models with up-to-date scientific wind energy yield assessment models to have a more realistic look on the feasibility of such an approach. The results show that, with the assumption of no extra support structure and capital loan costs, a project can be feasible with bigger then 8MW wind turbines. These may involve a large initial investment but the return of the investment (ROI) can be as low as 8 years. With bigger turbines, profit can be increased, and ROI can be decreased while the Levelized Cost of Energy (LCOE) displays minor decrease after 10 MW.Article Citation - WoS: 6Citation - Scopus: 9Impact of Climate Change on Indoor Environment of Historic Libraries in Mediterranean Climate Zone(Inderscience Enterprises, 2019) Turhan, Cihan; Durmuş Arsan, Zeynep; Gökçen Akkurt, GüldenMost historic library buildings house valuable paper-based collections that are kept in unconditioned environments. This vulnerable cultural heritage is expected to be highly affected by climate change in the future. In this study, indoor microclimate of an unconditioned historic library, Necip Pasa Library (Izmir, Turkey) is analysed for existing conditions and future climate data. The measured and predicted indoor microclimate data from 'present' till 2080s are used to determine possible chemical degredation risk on library collection and human comfort. Comparison of periodic results of future climate data indicates an increase in temperature that could cause both an increase in chemical degredation risk on the library collection and a decline in thermal comfort conditions. Mitigation of climate change effects on library collection and human comfort requires taking some actions such as adding light and adaptive mechanical solutions.Article Citation - WoS: 7Inertia and Droop Controller for a Modern Variable Speed Wind Turbine To Provide Frequency Control in a Microgrid(Gazi Üniversitesi, 2020) Hassan, Ali; Altın, Müfit; Bingöl, FerhatThe increasing penetration of modern Variable Speed Wind Turbines (VSWTs) in microgrids creates the problem of frequency stabilization due to reduced inertia of the power system. To emulate the Inertia Response of the conventional synchronous machines, wind turbines can be provided with an inertia emulation controller. The modeling presented in this paper aims at equipping the modern Type D wind turbine with inertia response and primary frequency control (PFC) capabilities. Two controllers - inertial and droop, are implemented and their frequency control capabilities are compared in an isolated power system which consists of a conventional steam turbine generator and a wind farm. The results suggest that proposed controllers help in better frequency control performance in the microgrid.Article Citation - WoS: 7Citation - Scopus: 8Performance Indices of Soft Computing Models To Predict the Heat Load of Buildings in Terms of Architectural Indicators(Yıldız Teknik Üniversitesi, 2017) Turhan, Cihan; Kazanasmaz, Zehra Tuğçe; Gökçen Akkurt, GüldenThis study estimates the heat load of buildings in Izmir/Turkey by three soft computing (SC) methods; Artificial Neural Networks (ANNs), Fuzzy Logic (FL) and Adaptive Neuro-based Fuzzy Inference System (ANFIS) and compares their prediction indices. Obtaining knowledge about what the heat load of buildings would be in architectural design stage is necessary to forecast the building performance and take precautions against any possible failure. The best accuracy and prediction power of novel soft computing techniques would assist the practical way of this process. For this purpose, four inputs, namely, wall overall heat transfer coefficient, building area/ volume ratio, total external surface area and total window area/total external surface area ratio were employed in each model of this study. The predicted heat load is evaluated comparatively using simulation outputs. The ANN model estimated the heat load of the case apartments with a rate of 97.7% and the MAPE of 5.06%; while these ratios are 98.6% and 3.56% in Mamdani fuzzy inference systems (FL); 99.0% and 2.43% in ANFIS. When these values were compared, it was found that the ANFIS model has become the best learning technique among the others and can be applicable in building energy performance studies.Article Citation - WoS: 7Citation - Scopus: 7The Importance of Internal Heat Gains for Building Cooling Design(Yıldız Teknik Üniversitesi, 2017) Coşkun, Turgay; Turhan, Cihan; Durmuş Arsan, Zeynep; Gökçen Akkurt, GüldenThis paper aims to investigate the effect of internal heat gains on the cooling load of a building. The house occupied by three adult men is selected as the case study for paper. The house is in the third floor of the apartment. The apartment has four flats and it has no insulation around the external walls. The heat dissipation from lighting devices, electrical equipment and the occupants are calculated by using the DesignBuilder v4 Beta release simulation program. The temperature of the house is observed during three weeks by using hobo data loggers and calibration of the measurements is made with respect to weather data file of the flat. Detailed schedule based on time of operation and occupancy is prepared to get more accurate results. Annual energy consumption and cooling load of the house is determined by using the dynamic simulation program.