Sürdürülebilir Yeşil Kampüs Koleksiyonu / Sustainable Green Campus Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7755
Browse
60 results
Search Results
Article Citation - WoS: 16Citation - Scopus: 20Groundwater Recharge Estimation Using Hydrus 1d Model in Alaşehir Sub-Basin of Gediz Basin in Turkey(Springer Verlag, 2019) Tonkul, Serhat; Baba, Alper; Şimşek, Celalettin; Durukan, Seda; Demirkesen, Ali Can; Tayfur, GökmenGediz Basin, located in the western part of Turkey constituting 2% land of the country, has an important groundwater potential in the area. Alasehir sub-basin, located in the southeast of the Gediz Basin and subject to the extensive withdrawal for the irrigation, constitutes the study area. Natural recharge to the sub-basin due to precipitation is numerically investigated in this study. For this purpose, 25 research wells, whose depths range from 20 to 50 m, were drilled to observe the recharge and collect the necessary field data for the numerical model. Meteorological data were collected from 3 weather stations installed in the study area. The numerical model HYDRUS was calibrated using the field water content data. Soil characterization was done on the core samples; the aquifer characterization was performed, and the alluvial aquifer recharge due to precipitation was calculated. As a result, the computed recharge value ranges from 21.78 to 68.52 mm, with an average value of 43.09 mm. According to the numerical model, this amount of recharge corresponds to 10% of the amount of annual rainfall.Article Citation - WoS: 2Citation - Scopus: 2A Deterministic and Stochastic Assessment for Exposure and Risk of Arsenic Via Ingestion of Edible Crops(Springer Verlag, 2019) Can Terzi, Begüm; Gündüz, Orhan; Sofuoğlu, Sait CemilNatural arsenic contamination is a critical problem for various places around the world. Simav Plain (Kutahya, Turkey) is one such area that was shown to have natural arsenic contamination in its waters and soils. Arsenic exposure through ingestion of edible crops cultivated in Simav Plain and associated health risks were assessed in this study. To achieve this objective, arsenic levels in 18 crop species were estimated based on measured soil arsenic concentrations. Individual and aggregate non-carcinogenic and carcinogenic risks associated with ingestion of arsenic-contaminated crops were then assessed with scenario-based deterministic point estimates and stochastic population estimates. Monte Carlo simulation was used for the estimation of population health risks. Accordingly, wheat was found as the highest-ranked crop specie for the both types of health risks, followed by tomato and potato, which are three of the most consumed crops in the region. The risk levels estimated in this study were relatively high, indicating consumption of crops grown in the plain may be posing significant health risks even at lower-bound estimates. Consuming wheat, tomato, potato, and their products from uncontaminated sources was found to reduce the aggregate risks up to 88% implicating the importance of proposing suitable management measures for similar risk-prone areas.Article Citation - WoS: 2Citation - Scopus: 3Integrating Spatiotemporal Dynamics of Natural Capital Security and Urban Ecosystem Carbon Metabolism(Springer Verlag, 2018) Demirkesen, Ali Can; Evrendilek, FatihThe purpose of the study is to address and quantify the increase in urban expansion and carbon (C) metabolism burden on ecosystem service value (ESV), net ecosystem productivity (NEP), and C storage of urban footprint. Urban footprint is required to meet the demands arising from economic consumption and production as well as waste accumulation and assimilation. Spatiotemporal changes in main land covers (LCs) were detected using remotely sensed data (Landsat 5 and 8, and digital elevation model) between 1987 and 2016. Changes in ESV and C influx, efflux and pools associated with LC dynamics were approximated using global proxies for a western Mediterranean region in Turkey of 54,162 km2. Urban expansion over the 29-year period decreased ESV by 22% ($7.28 ± 0.4 billion), NEP by 4.3% (2.3 ± 9 Gg C), and total ecosystem C pool by 10.9% (1008.3 ± 1006 Gg C) and led to a 62.8% appropriation of the total NEP (50.1 ± 51 Gg C) of the urban footprint in 2016. The main cause of the environmental degradation across the study region was the loss of the seminatural areas. Our findings emphasize that the deterioration rate of ecosystems should be slowed down by natural capital-friendly decisions and should not exceed rehabilitation rate of damaged ecosystems in the face of rapidly increasing burdens of the cities on their footprint.Article Citation - WoS: 19Citation - Scopus: 29Modeling of an Activated Sludge Process for Effluent Prediction—a Comparative Study Using Anfis and Glm Regression(Springer Verlag, 2018) Araromi, Dauda Olurotimi; Majekodunmi, Olukayode Titus; Adeniran, Jamiu Adetayo; Salawudeen, Taofeeq OlalekanIn this paper, nonlinear system identification of the activated sludge process in an industrial wastewater treatment plant was completed using adaptive neuro-fuzzy inference system (ANFIS) and generalized linear model (GLM) regression. Predictive models of the effluent chemical and 5-day biochemical oxygen demands were developed from measured past inputs and outputs. From a set of candidates, least absolute shrinkage and selection operator (LASSO), and a fuzzy brute-force search were utilized in selecting the best combination of regressors for the GLMs and ANFIS models respectively. Root mean square error (RMSE) and Pearson’s correlation coefficient (R-value) served as metrics in assessing the predicting performance of the models. Contrasted with the GLM predictions, the obtained modeling results show that the ANFIS models provide better predictions of the studied effluent variables. The results of the empirical search for the dominant regressors indicate the models have an enormous potential in the estimation of the time lag before a desired effluent quality can be realized, and preempting process disturbances. Hence, the models can be used in developing a software tool that will facilitate the effective management of the treatment operation.Article Citation - WoS: 32Citation - Scopus: 37Mcdm Analysis of Wind Energy in Turkey: Decision Making Based on Environmental Impact(Springer Verlag, 2018) Değirmenci, Sinem; Bingöl, Ferhat; Sofuoğlu, Sait CemilDevelopment of new wind energy projects require complex planning process involving many social, technical, economic, environmental, political concerns, and different agents such as investors, utilities, governmental agencies, or social groups. The aim of this study is to develop a tool combining Geographic Information System (GIS) and Multi-Criteria Decision-Making (MCDM) methodologies, and its application for Turkey as a case study. A variety of constraints and criteria were identified based on a literature review and regulations gathered from variety of agencies, use of which resulted in determination of infeasible sites. Then, pairwise comparisons were carried out using analytic hierarchy process as the MCDM method to estimate relative importance of the criteria, and to visualize a suitability map with three classes. As the final stage, decision making was carried out based on environmental impact where 45.5% of the Turkish territory was found as infeasible area. Sixty percent of the remaining area are covered by the moderate suitability class, followed by the highly suitable area (20.3%) and low suitable area (19.8%). The output of this study can be used by energy planners to estimate the extent that wind energy can be developed based on public perception, administrative, and environmental aspectsArticle Citation - WoS: 3Citation - Scopus: 3Channel and Queue Aware Joint Relay Selection and Resource Allocation for Miso-Ofdma Based User-Relay Assisted Cellular Networks(Springer Verlag, 2018) Baştürk, İlhan; Özbek, BernaUser-relay assisted orthogonal frequency division multiple access (OFDMA) networks are cost-effective solutions to meet the growing capacity and coverage demands of the next generation cellular networks. These networks can be used with multiple antennas technology in order to obtain a diversity gain to combat signal fading and to obtain more capacity gain without increasing the bandwidth or transmit power. Efficient relay selection and resource allocation are crucial in such a multi-user, multi-relay and multi-antenna environment to fully exploit the benefits of the combination of user-relaying and multiple antennas technology. Thus, we propose a channel and queue aware joint relay selection and resource allocation algorithm for multiple-input single-output (MISO)-OFDMA based user-relay assisted downlink cellular networks. Since, the proposed algorithm is not only channel but also queue-aware, the system resources are allocated efficiently among the users. The proposed algorithm for the MISO-OFDMA based user-relay assisted scheme is compared to existing MISO-OFDMA based non-relaying and fixed relay assisted schemes and it is also compared with the existing single-input single-output (SISO)-OFDMA based user-relay assisted scheme. Simulation results revealed that the proposed scheme outperforms the existing schemes in terms of cell-edge users’ total data rate, average backlog and average delay.Book Part Control Methods for a Teleoperated Endoscope Robot(Springer Verlag, 2019) Işıtman, Oğulcan; Dede, Mehmet İsmet CanIn this study, control of a endoscope robot for the pituitary gland surgery is presented. This co-worker robot has non-backdrivable actuation system with external brakes on the actuators. Since it is required to move in a constrained environment, which is the inside the nostrils in this case, modifications are required for the motion controller. In order to provide safe procedure, the maximum force and torque limits are defined for the real surgical case by using human cadaver head. By considering these limits and application specific requirements, a compliance controller is proposed and experimentally tested.Article Citation - WoS: 2Citation - Scopus: 4Removal of Metals and Metalloids From Acidic Mining Lake (aml) Using Olive Oil Solid Waste (osw)(Springer Verlag, 2019) İlay, Remzi; Baba, Alper; Kavdır, YaseminThe acidic mining lakes have low pH values and high metal and metalloid concentrations. In this study, the ability of low-cost olive oil solid waste (OSW) to remove Al, As, Cd, Fe, B and Ti ions from aqueous solutions in short term has been evaluated. Adsorption capacities (mg g−1) of OSW (1:5–1:10 w/v) were 764.06–411.75 for Al, 0.26 for As, 0.07–0.14 for Cd, 2181.5–2406.5 for Fe, 23.70–82.50 for B and 0.12–0.0.34 for Ti. OSW addition increased acidic mine water (AMW) pH from 2.41 to 3.2 with 1:5 and from 2.41 to 2.7 to 1:10 mixing ratio, respectively, after 10 min. The best gradual decrease has been observed with different ratio of OSW applications on B and Ti concentrations. OSW adsorbs 32.41% and 62.68% of B at the ratio of 1:5 and 1:10 and 55.29% and 83.04% of Ti at the ratio of 1:5 and 1:10 (OSW:AMW) mixtures, respectively. The results show that OSW has great potential for metal removal from acidic mine water.Book Part Citation - WoS: 2Citation - Scopus: 2Energetic and Exergetic Design Evaluations of a Building Block Based on a Hybrid Solar Envelope Method(Springer Verlag, 2018) Mert, Yelda; Saygın, NicelTo achieve sustainable development, there needs to be a focus on decreasing use of non-renewable energy sources and greenhouse gas emissions. In this regard, many studies focus on the strong relationship between energy and the environment. This study aimed to introduce the exergy analysis method into the urban planning field to find out the amount of exergy, rather than energy, that can be conserved in a building block when a solar envelope-based design is applied. In addition to the known energy-efficient design parameters, a criterion for the solar envelop method is integrated into a single method. This hybrid method includes taking into account the requirements for orientation, spacing, landscaping, and building form, as well as the building height properties as proposed in the solar envelop method. The solar envelop method depends on understanding the changing position of the sun throughout the day and year. If this dynamic behavior can be a factor in the design of an urban area, environmental friendliness, sustainability, and reduced energy consumption can comprehensively be achieved in cities.Conference Object Citation - Scopus: 3Design and Simulation of a Novel Hybrid Leg Mechanism for Walking Machines(Springer Verlag, 2018) Demirel, Murat; Carbone, Giuseppe; Ceccarelli, Marco; Kiper, GökhanThis paper introduces a novel hybrid structure design that is composed of rigid links and cables for a robotic leg with static walking. The proposed mechanism is characterized by actuated hip joints, passive knee joints and an actuated prismatic foot joint. The foot is the moving platform of the proposed mechanism which possesses pure translational motion due to the passive parallelograms with cables. Kinematic analysis has been worked out for evaluating a typical human-like gait trajectory. A 3-D model has been developed and simulation are made in SolidWorks® environment. Simulation results show that the proposed mechanism is able to perform an ovoid walking cycle of a foot point and the computed actuator torques and forces are in a feasible range for a low-cost and easy-operation design. The simulation results will be used for a prototype construction in a future work.