Sürdürülebilir Yeşil Kampüs Koleksiyonu / Sustainable Green Campus Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7755
Browse
3 results
Search Results
Article Citation - WoS: 8Citation - Scopus: 8Reducing Marble-So2 Reaction Rate by the Application of Certain Surfactants(Springer Verlag, 2003) Böke, Hasan; Gauri, K. LalSulfur dioxide (SO2), prevalent in the modern urban environment of industrial countries, attacks calcite (CaCO3) in marble. As a result, a gypsum (CaSO4.2H2O) crust is produced at rain-sheltered surfaces while areas exposed to rain experience accelerated erosion. We have investigated the effect of certain surfactants as protective agents against SO2 attack. We report that the anions oxalate (C2O4-2) and oleate (C17H33COO-) from solutions of their highly soluble alkali salt species are able to replace carbonate (CO3-2) in calcite producing less reactive substrate of oxalate and oleate of calcium. Experiments to measure the protection obtained by these treatments were carried out in the laboratory and field conditions at nearly 1 ppm and 10 ppb SO2 concentrations, respectively. We found that these treatments provided significant protection to marble exposed in sheltered areas, up to 30% reduction of reaction rate by treatment with 2 × 10-4 M sodium oleate and up to 14% by a 2 × 10-3 M with potassium oxalate solutions, but become ineffective over long term exposure when applied to surfaces exposed to rain. Carrara marble was used in the reported study. Ion chromatography was the analytical tool, which allowed precise measurements of ionic concentrations of these salts, the amount of their uptake by marble, and the thickness of the gypsum crust. X-ray diffraction allowed determination of the new minerals formed at the marble surface by the treatment with surfactants.Article Citation - WoS: 14Citation - Scopus: 15Chitosan-Immobilized Pumice for the Removal of As(v) From Waters(Springer Verlag, 2014) Turan, Dilek; Kocahakimoğlu, Cemre; Boyacı, Ezel; Sofuoğlu, Sait Cemil; Eroğlu, Ahmet EminA novel sorbent, chitosan-immobilized pumice, has been prepared for the sorption of As(V) from waters prior to its determination by hydride generation atomic absorption spectrometry. The success of the immobilization has been checked with such characterization techniques as scanning electron microscopy, thermal gravimetric analysis, and elemental analysis. Points of zero charge of the sorbents were determined with potentiometric mass titration. Batch-type equilibration studies have shown that the novel sorbent can be employed at a wide pH range resulting in quantitative sorption (>90 %) at pH 3.0-7.0 and greater than 70 % sorption at pH >8.0. These results demonstrate the advantage of immobilizing chitosan onto pumice, because, under the same conditions, pumice displays <20 % sorption toward As(V), whereas chitosan gives approximately 90%sorption only at pH 3.0. The validity of the method was verified through the analysis of ultrapure, bottled drinking, and tap water samples spiked with arsenate; the respective sorption percentages of 93.2 (±0.7), 89.0 (±1.0), and 80.9 (±1.3) were obtained by batch-type equilibration. Arsenic sorption was also examined in the presence of common interfering ions resulting in competing effects of PO3- 4 and NO- 3on As(V) adsorption.Article Citation - WoS: 21Citation - Scopus: 23Activated Carbon Adsorption of Fuel Oxygenates Mtbe and Etbe From Water(Springer Verlag, 2009) İnal, Fikret; Yetgin, Senem; Aksu, Gülsüm T.; Şimşek, Selvi; Sofuoğlu, Aysun; Sofuoğlu, Sait CemilThe aqueous phase adsorption of fuel oxygenates methyl tertiary butyl ether (MTBE) and ethyl tertiary butyl ether (ETBE) onto commercially available granular activated carbon (GAC; Norit GAC 1240) was investigated in a batch system at 27°C. The oxygenate concentrations were determined by headspace gas chromatography/mass spectrometry analyses. The experimental data were used with four two-parameter isotherm models (Langmuir, Freundlich, Temkin, and Dubinin-Radushkevich) and two kinetic models (pseudo first-order and pseudo second-order) to determine equilibrium and kinetic parameters. Considering the correlation coefficient and root mean square error, Dubinin-Radushkevich isotherm showed better fit with the equilibrium data for MTBE. However, the performances of Langmuir and Dubinin-Radushkevich models were comparable for ETBE. The adsorption capacities were calculated as 5.50 and 6.92 mg/g for MTBE and ETBE, respectively, at an equilibrium solution concentration of 1 mg/L using Dubinin-Radushkevich isotherm. The differences between the model predictions and experimental data were similar for the pseudo first-order and pseudo second-order kinetic models. Gibbs free-energy changes of adsorption were found to be -22.59 and -28.55 kJ/mol for MTBE-GAC and ETBE-GAC systems, respectively, under the experimental conditions studied.