PubMed İndeksli Yayınlar Koleksiyonu / PubMed Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7645
Browse
3 results
Search Results
Conference Object Citation - WoS: 24Effect of pH and Hydration on the Normal and Lateral Interaction Forces Between Alumina Surfaces(2006) Polat, Mehmet; Sato, Kimiyasu; Nagaoka, Takaaki; Watari, KojiNormal and lateral interaction forces between alumina surfaces were measured using Atomic Force Microscopy-Colloid Probe Method at different pH. The normal force curves exhibit a well-defined repulsive barrier and an attractive minimum at acidic pH and the DLVO theory shows excellent agreement with the data. The normal forces are always repulsive at basic pH and the theory fails to represent the measurements. Lateral forces are almost an order of magnitude smaller in the basic solutions. These differences, which have important implications in the study of stability and rheology, are attributed to the hydration of the alumina surface at basic pH. © 2013 Elsevier B.V., All rights reserved.Article Citation - WoS: 2Citation - Scopus: 2Scanning Probe Oxidation Lithography on Ta Thin Films(American Scientific Publishers, 2008) Okur, Salih; Büyükköse, Serkan; Tarı, SüleymanA Semi-Contact Scanning Probe Lithography Technique (SC-SPL) has been applied to create nano-oxide patterns on Ta thin films grown by DC magnetron sputtering method on SiO 2/Si substrates. The height and linewidth profiles of nano-oxide lines created by a conductive AFM tip on Ta film surfaces were measured as a function of applied voltage, oxidation time, humidity, and tip apex curvature. The AFM surface measurements show that the height of the oxides increases linearly with increasing voltage; but there was no oxide growth, when less than 4 V was applied even at 85% relative humidity. Electrical measurements were performed and the resistivities of the TaO x layer and Ta film were obtained as 5.76 × 10 8 and 1.4 × 10 5 Ohm-cm, respectively.Book Part Citation - WoS: 21Citation - Scopus: 24Metals Foams for Biomedical Applications: Processing and Mechanical Properties(Springer, 2004) Güden, Mustafa; Çelik, Emrah; Çetiner, Sinan; Aydın, AlptekinOptimized structures found in nature can be sometimes imitated in engineering structures. The recent interest in functionally graded metallic materials makes bone structures interesting because bones are naturally functionally graded1. The cellular structure of foam metals (Fig.1) is very similar to that of the cancellous bone; therefore, these metals can be considered as potential candidates for future implant applications if porosity level, size and shape, strength and biocompatibility aspects satisfy the design specifications of implants. Foam metals based on biocompatible metallic materials (e.g. Ti and Ti-6A1-4V) are expected to provide better interaction with bone. This is mainly due to higher degree of bone growth into porous surfaces and higher degree of body fluid transport through three-dimensional interconnected array of pores2 (open cell foam), leading to better interlocking between implant and bone and hence reducing or avoiding the well-known implant losening. Furthermore, the elastic modulus of foam metals can be easily tailored with porosity level to match that of natural bone, leading to a better performance by avoiding the high degree of elastic mismatch which currently exists between conventional solid metallic implants and bone.