PubMed İndeksli Yayınlar Koleksiyonu / PubMed Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7645
Browse
6 results
Search Results
Now showing 1 - 6 of 6
Article Citation - WoS: 7Citation - Scopus: 8Hydrogenation-driven phase transition in single-layer TiSe2(IOP Publishing Ltd., 2017) İyikanat, Fadıl; Kandemir, Ali; Özaydın, H. Duygu; Senger, Ramazan Tuğrul; Şahin, HasanFirst-principles calculations based on density-functional theory are used to investigate the effects of hydrogenation on the structural, vibrational, thermal and electronic properties of the charge density wave (CDW) phase of single-layer TiSe2. It is found that hydrogenation of single-layer TiSe2 is possible through adsorption of a H atom on each Se site. Our total energy and phonon calculations reveal that a structural phase transition occurs from the CDW phase to the T d phase upon full hydrogenation. Fully hydrogenated TiSe2 presents a direct gap semiconducting behavior with a band gap of 119 meV. Full hydrogenation also leads to a significant decrease in the heat capacity of single-layer TiSe2.Article Citation - WoS: 7Citation - Scopus: 7Stable Ultra-Thin Cdte Crystal: a Robust Direct Gap Semiconductor(IOP Publishing Ltd., 2017) İyikanat, Fadıl; Akbalı, Barış; Kang, J.; Senger, Ramazan Tuğrul; Selamet, Yusuf; Şahin, HasanEmploying density functional theory based calculations, we investigate structural, vibrational and strain-dependent electronic properties of an ultra-thin CdTe crystal structure that can be derived from its bulk counterpart. It is found that this ultra-thin crystal has an 8-atom primitive unit cell with considerable surface reconstructions. Dynamic stability of the structure is predicted based on its calculated vibrational spectrum. Electronic band structure calculations reveal that both electrons and holes in single layer CdTe possess anisotropic in-plane masses and mobilities. Moreover, we show that the ultra-thin CdTe has some interesting electromechanical features, such as strain-dependent anisotropic variation of the band gap value, and its rapid increase under perpendicular compression. The direct band gap semiconducting nature of the ultra-thin CdTe crystal remains unchanged under all types of applied strain. With a robust and moderate direct band gap, single-layer CdTe is a promising material for nanoscale strain dependent device applications.Article Citation - WoS: 6Citation - Scopus: 6Few-Layer Mos2 as Nitrogen Protective Barrier(IOP Publishing Ltd., 2017) Akbalı, Barış; Yanılmaz, Alper; Tomak, Aysel; Tongay, Sefaattin; Çelebi, Cem; Şahin, HasanWe report experimental and theoretical investigations of the observed barrier behavior of few-layer MoS2 against nitrogenation. Owing to its low-strength shearing, low friction coefficient, and high lubricity, MoS2 exhibits the demeanor of a natural N-resistant coating material. Raman spectroscopy is done to determine the coating capability of MoS2 on graphene. Surface morphology of our MoS2/graphene heterostructure is characterized by using optical microscopy, scanning electron microscopy, and atomic force microscopy. In addition, density functional theory-based calculations are performed to understand the energy barrier performance of MoS2 against nitrogenation. The penetration of nitrogen atoms through a defect-free MoS2 layer is prevented by a very high vertical diffusion barrier, indicating that MoS2 can serve as a protective layer for the nitrogenation of graphene. Our experimental and theoretical results show that MoS2 material can be used both as an efficient nanocoating material and as a nanoscale mask for selective nitrogenation of graphene layer.Article Citation - WoS: 8Citation - Scopus: 10Stability, Electronic and Phononic Properties of Ss and 1t Structures of Sitex (x = 1, 2) and Their Vertical Heterostructures(IOP Publishing Ltd., 2017) Kandemir, Ali; İyikanat, Fadıl; Şahin, HasanBy performing first-principles calculations, we predict a novel, stable single layer phase of silicon ditelluride, 1T-SiTe2, and its possible vertical heterostructures with single layer β-SiTe. Structural optimization and phonon calculations reveal that 1T-SiTe2 structure has a dynamically stable ground state. Further analysis of the vibrational spectrum at the - point shows that single layer 1T-SiTe2 has characteristic phonon modes at 80, 149, 191 and 294 cm-1. Electronic-band structure demonstrates that 1T-SiTe2 phase exhibits a nonmagnetic metallic ground state with a negligible intrinsic spinorbit splitting. Moreover, it is shown that similar structural parameters of 1T-SiTe2 and existing β-SiTe phases allows construction of 1T-β heterostructures with a negligible lattice mismatch. In this regard, it is found that two energetically favorable stacking orders, namely AA and ATB, have distinctive shear and layer breathing phonon modes. It is important to note that the combination of semiconducting β-SiTe and metallic 1T-SiTe2 building blocks forms ultra-thin Schottky barriers that can be used in nanoscale optoelectronic device technologies.Article Citation - WoS: 2Citation - Scopus: 2Structural Changes in a Schiff Base Molecular Assembly Initiated by Scanning Tunneling Microscopy Tip(IOP Publishing Ltd., 2016) Tomak, Aysel; Bacaksız, Cihan; Mendirek, Gizem; Şahin, Hasan; Hür, Deniz; Görgün, Kamuran; Senger, Ramazan Tuğrul; Birer, Özgür; Peeters, François M.; Zareie, Hadi M.We report the controlled self-organization and switching of newly designed Schiff base (E)-4-((4-(phenylethynyl) benzylidene) amino) benzenethiol (EPBB) molecules on a Au (111) surface at room temperature. Scanning tunneling microscopy and spectroscopy (STM/STS) were used to image and analyze the conformational changes of the EPBB molecules. The conformational change of the molecules was induced by using the STM tip while increasing the tunneling current. The switching of a domain or island of molecules was shown to be induced by the STM tip during scanning. Unambiguous fingerprints of the switching mechanism were observed via STM/STS measurements. Surface-enhanced Raman scattering was employed, to control and identify quantitatively the switching mechanism of molecules in a monolayer. Density functional theory calculations were also performed in order to understand the microscopic details of the switching mechanism. These calculations revealed that the molecular switching behavior stemmed from the strong interaction of the EPBB molecules with the STM tip. Our approach to controlling intermolecular mechanics provides a path towards the bottom-up assembly of more sophisticated molecular machines.Article Citation - WoS: 26Citation - Scopus: 26Controlled Growth Mechanism of Poly (3-Hexylthiophene) Nanowires(IOP Publishing Ltd., 2016) Kıymaz, D.; Yağmurcukardeş, Mehmet; Tomak, Aysel; Şahin, Hasan; Senger, Ramazan Tugrul; Peeters, François M.; Zareie, Hadi M.; Zafer, CeylanSynthesis of 1D-polymer nanowires by a self-assembly method using marginal solvents is an attractive technique. While the formation mechanism is poorly understood, this method is essential in order to control the growth of nanowires. Here we visualized the time-dependent assembly of poly (3-hexyl-thiophene-2,5-diyl) (P3HT) nanowires by atomic force microscopy and scanning tunneling microscopy. The assembly of P3HT nanowires was carried out at room temperature by mixing cyclohexanone (CHN), as a poor solvent, with polymer solution in 1,2-dichlorobenzene (DCB). Both π-π stacking and planarization, obtained at the mix volume ratio of P3HT (in DCB):CHN (10:7), were considered during the investigation. We find that the length of nanowires was determined by the ordering of polymers in the polymer repetition direction. Additionally, our density functional theory calculations revealed that the presence of DCB and CHN molecules that stabilize the structural distortions due to tail group of polymers was essential for the core-wire formation.