PubMed İndeksli Yayınlar Koleksiyonu / PubMed Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7645
Browse
8 results
Search Results
Now showing 1 - 8 of 8
Article Citation - WoS: 3Citation - Scopus: 3Compact Multilayer Thin-Film Color Filters and Direct Integration on White-Light Diodes for Color Conversion(Optical Society of America, 2021) Yiğen, Serap; Ekmekçioğlu, Merve; Özdemir, Mehtap; Aygün, Gülnur; Özyüzer, LütfiWe present highly efficient green, yellow, and red filters based on a metal-dielectric structure. The filters encompass only five layers of alternating zinc tin oxide and silver thin films that are grown on soda lime glass and white light-emitting diodes (LEDs) using direct current magnetron sputtering at room temperature. The designed filters provide efficient color filtering in the visible spectrum. High purity colored light is obtained by direct application of filters on LEDs as color converters. The presented method offers an easy way for realizing different colors by tuning the thicknesses of layers in the structure. (C) 2021 Optical Society of AmericaArticle Citation - WoS: 11Citation - Scopus: 13Effect of Cnt Incorporation on Pan/Ppy Nanofibers Synthesized by Electrospinning Method(TÜBİTAK, 2020) İnce Yardımcı, Atike; Tanoğlu, Metin; Yılmaz, Selahattin; Selamet, YusufIn this study, carbon nanotubes (CNTs) added polyacrylonitrile/polypyrrole (PAN/PPy) electrospun nanofibers were produced. Average diameters of the nanofibers were measured as 268 and 153 nm for 10 and 25 wt% of PPy contents, respectively. A relatively higher strain to failure values (23.3%) were observed for the low PPy content. When as-grown CNTs (1 and 4 wt%) were added into the PAN/PPy blends, disordered nanofibers were observed to form within the microstructure. To improve the interfacial properties of CNTs/PAN/PPy composites, CNTs were functionalized with H2SO4/HNO3/HCl solution. The functionalized CNTs were well dispersed within the nanofibers and aligned along the direction of nanofibers. Therefore, beads formation on nanofibers decreased. The impedance of the nanofibers was found to decrease with the PPy content and CNT addition. These nanofibers had a great potential to be used as an electrochemical actuator or a tissue engineering scaffold.Article Citation - WoS: 7Citation - Scopus: 7Stable Ultra-Thin Cdte Crystal: a Robust Direct Gap Semiconductor(IOP Publishing Ltd., 2017) İyikanat, Fadıl; Akbalı, Barış; Kang, J.; Senger, Ramazan Tuğrul; Selamet, Yusuf; Şahin, HasanEmploying density functional theory based calculations, we investigate structural, vibrational and strain-dependent electronic properties of an ultra-thin CdTe crystal structure that can be derived from its bulk counterpart. It is found that this ultra-thin crystal has an 8-atom primitive unit cell with considerable surface reconstructions. Dynamic stability of the structure is predicted based on its calculated vibrational spectrum. Electronic band structure calculations reveal that both electrons and holes in single layer CdTe possess anisotropic in-plane masses and mobilities. Moreover, we show that the ultra-thin CdTe has some interesting electromechanical features, such as strain-dependent anisotropic variation of the band gap value, and its rapid increase under perpendicular compression. The direct band gap semiconducting nature of the ultra-thin CdTe crystal remains unchanged under all types of applied strain. With a robust and moderate direct band gap, single-layer CdTe is a promising material for nanoscale strain dependent device applications.Article Citation - WoS: 8Citation - Scopus: 10Stability, Electronic and Phononic Properties of Ss and 1t Structures of Sitex (x = 1, 2) and Their Vertical Heterostructures(IOP Publishing Ltd., 2017) Kandemir, Ali; İyikanat, Fadıl; Şahin, HasanBy performing first-principles calculations, we predict a novel, stable single layer phase of silicon ditelluride, 1T-SiTe2, and its possible vertical heterostructures with single layer β-SiTe. Structural optimization and phonon calculations reveal that 1T-SiTe2 structure has a dynamically stable ground state. Further analysis of the vibrational spectrum at the - point shows that single layer 1T-SiTe2 has characteristic phonon modes at 80, 149, 191 and 294 cm-1. Electronic-band structure demonstrates that 1T-SiTe2 phase exhibits a nonmagnetic metallic ground state with a negligible intrinsic spinorbit splitting. Moreover, it is shown that similar structural parameters of 1T-SiTe2 and existing β-SiTe phases allows construction of 1T-β heterostructures with a negligible lattice mismatch. In this regard, it is found that two energetically favorable stacking orders, namely AA and ATB, have distinctive shear and layer breathing phonon modes. It is important to note that the combination of semiconducting β-SiTe and metallic 1T-SiTe2 building blocks forms ultra-thin Schottky barriers that can be used in nanoscale optoelectronic device technologies.Article Citation - WoS: 3Citation - Scopus: 2?-Silicene as Oxidation-Resistant Ultra-Thin Coating Material(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2017) Kandemir, Ali; İyikanat, Fadıl; Bacaksız, Cihan; Şahin, HasanBy performing density functional theory (DFT)-based calculations, the performance of a-silicene as oxidation-resistant coating on Ag(111) surface is investigated. First of all, it is shown that the Ag(111) surface is quite reactive against O atoms and O2 molecules. It is known that when single-layer silicene is formed on the Ag(111) surface, the 3 × 3-reconstructed phase, a-silicene, is the ground state. Our investigation reveals that as a coating layer, a-silicene (i) strongly absorbs single O atoms and (ii) absorbs O2 molecules by breaking the strong O-O bond. (iii) Even the hollow sites, which are found to be most favorable penetration path for oxygens, serves as high-energy oxidation barrier, and (iv) α-silicene becomes more protective and less permeable in the presence of absorbed O atom. It appears that single-layer silicene is a quite promising material for ultra-thin oxidation-protective coating applications.Article Citation - WoS: 1Citation - Scopus: 1Adsorption and Diffusion Characteristics of Lithium on Hydrogenated ?- and Ss-Silicene(Beilstein-Institut Zur Forderung der Chemischen Wissenschaften, 2017) İyikanat, Fadıl; Kandemir, Ali; Bacaksız, Cihan; Şahin, HasanUsing first-principles density functional theory calculations, we investigate adsorption properties and the diffusion mechanism of a Li atom on hydrogenated single-layer α- and β-silicene on a Ag(111) surface. It is found that a Li atom binds strongly on the surfaces of both α- and β-silicene, and it forms an ionic bond through the transfer of charge from the adsorbed atom to the surface. The binding energies of a Li atom on these surfaces are very similar. However, the diffusion barrier of a Li atom on H-α-Si is much higher than that on H-β-Si. The energy surface calculations show that a Li atom does not prefer to bind in the vicinity of the hydrogenated upper-Si atoms. Strong interaction between Li atoms and hydrogenated silicene phases and low diffusion barriers show that α- and β-silicene are promising platforms for Li-storage applications.Article Citation - WoS: 14Citation - Scopus: 14Quantum-Transport Characteristics of a P–n Junction on Single-Layer Tis3(John Wiley and Sons Inc., 2016) İyikanat, Fadıl; Senger, Ramazan Tuğrul; Peeters, François M.; Şahin, HasanBy using density functional theory and non-equilibrium Green′s function-based methods, we investigated the electronic and transport properties of a TiS3 monolayer p–n junction. We constructed a lateral p–n junction on a TiS3 monolayer using Li and F adatoms. An applied bias voltage caused significant variability in the electronic and transport properties of the TiS3 p–n junction. In addition, the spin-dependent current–voltage characteristics of the constructed TiS3 p–n junction were analyzed. Important device characteristics were found, such as negative differential resistance and rectifying diode behaviors for spin-polarized currents in the TiS3 p–n junction. These prominent conduction properties of the TiS3 p–n junction offer remarkable opportunities for the design of nanoelectronic devices based on a recently synthesized single-layered material.Article Citation - WoS: 24Citation - Scopus: 25Investigation of the Structure of Alpha-Lactalbumin Protein Nanotubes Using Optical Spectroscopy(Cambridge University Press, 2014) Tarhan, Özgür; Tarhan, Enver; Harsa, ŞebnemAlpha-lactalbumin (α-la) is one of the major proteins in whey. When partially hydrolysed with Bacillus licheniformis protease, it produces nanotubular structures in the presence of calcium ions by a self-assembly process. This study presents investigation of α-la protein structure during hydrolysis and nanotube formation using optical spectroscopy. Before spectroscopic measurements, nanotubes were examined with microscopy. The observed α-la nanotubes (α-LaNTs) were in the form of regular hollo strands with a diameter of about 20 nm and the average length of 1 μm. Amide and backbone vibration bands of the Raman spectra displayed remarkable conformational changes in α and β domains in the protein structure during nanotube growth. This was confirmed by the Fourier-transform infrared (FTIR) spectroscopy data. Also, FTIR analysis revealed certain bands at calcium (Ca++) binding sites of COO- groups in hydrolysed protein. These sites might be critical in nanotube elongation.