Food Engineering / Gıda Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/12
Browse
4 results
Search Results
Article Citation - WoS: 13Citation - Scopus: 14Evaluation of Orange Peel, an Industrial Waste, for the Production of Aspergillus Sojae Polygalacturonase Considering Both Morphology and Rheology Effects(TUBITAK, 2014) Gögüş, Nihan; Hakgüder Taze, Bengi; Demir, Hande; Tarı, Canan; Ünlütürk, Sevcan; Lahore, Marcelo FernandezOrange peel is an agroindustrial waste rich in pectin and known to be an inducer for pectinase production. The use of this low-cost substrate for the production of an industrially important enzyme, polygalacturonase (PG), can be an alternative way to turn this waste into a value-added product, contributing to the reduction of environmental waste disposal problems. Enzyme productions by fungal microorganisms are affected by environmental and nutritional factors, demanding the determination of optimum conditions for maximum enzyme production with the desired fungal morphology and broth rheology. Therefore, complex and additional carbon sources were optimized with respect to PG production by Aspergillus sojae using statistical approaches. Effect of pH, another significant parameter affecting the rheology and morphology of the strain, was investigated in the serial bioreactor system using the optimized medium composition. Highest PG enzyme yield and productivity together with the maximum PG enzyme production (93.48 U/mL) were obtained under uncontrolled pH conditions. Under these conditions, morphologically, pellet sizes exhibited a normal distribution ranging between 0.5-1.0 mm and 1.0-1.5 mm, and rheological measurements revealed that fermentation broths showed non-Newtonian flow. The low pH trend observed during the course of the fermentation was another important positive outcome for industrial fermentations, prone to contamination problems.Article Citation - WoS: 124Citation - Scopus: 144Use of Uv-C Radiation as a Non-Thermal Process for Liquid Egg Products (lep)(Elsevier Ltd., 2008) Ünlütürk, Sevcan; Atılgan, Mehmet Reşat; Baysal, Ayşe Handan; Tarı, CananThe efficacy of short wave ultraviolet light (UV-C) as a non-thermal process for liquid egg products (LEP) was investigated. Non-pathogenic Escherichia coli strain (ATCC 8739), which shows lower sensitivity to UV-C light than E. coli O157:H7 and Salmonella typhimurium, was chosen as a target microorganism. The inactivation of UV resistant strain of E. coli in LEP was examined by evaluating the effects of depth of liquid food medium (0.5, 0.3 and 0.153 cm), UV light intensity (1.314, 0.709 and 0.383 mW/cm2) and exposure time (0, 5, 10, and 20 min) by using a collimated beam apparatus. The best reduction (>2-log) was achieved in liquid egg white (LEW) when the fluid depth and UV intensity were 0.153 cm and 1.314 mW/cm2, respectively. Maximum inactivation was 0.675-log CFU/ml in liquid egg yolk (LEY) and 0.316-log CFU/ml in liquid whole egg (LWE) at the same conditions. The kinetics of UV inactivation of E. coli in LEP was nonlinear. Our results emphasize that UV-C radiation can be used as a pre-treatment process or combined with mild heat treatment to reduce the adverse effects of thermal pasteurization of LEP.Article Citation - WoS: 33Citation - Scopus: 37Relationship Between Morphology, Rheology and Polygalacturonase Production by Aspergillus Sojae Atcc 20235 in Submerged Cultures(Elsevier Ltd., 2006) Göğüş, Nihan; Tarı, Canan; Öncü, Şelale; Ünlütürk, Sevcan; Tokatlı, FigenA full factorial statistical design, with the factors of, two taxonomically different strains, seven types of seed culture formulations (slants) and two types of fermentation media were used to investigate the effect of these parameters on the morphology and polygalacturonase production. The rheology of the final fermentation medium was analyzed and appropriate mathematical model was applied to calculate suspension viscosity. It was found that most fermentation broths showed non-Newtonian flow behavior. According to statistical analysis, factors of strain types and fermentation media and the interaction between them were found significant on the enzyme activity. The effect of seed culture formulations (slants) were found insignificant at the significance level of 1%. Interaction of slants with strain types and fermentation media were also found insignificant. Considering the morphology of the final culture, Aspergillus sojae with the desired pellet morphology in a complex media, inoculated with a seed culture prepared from molasses resulted in maximum polygalacturonase enzyme activity (0.2 U/ml) and lowest suspension viscosity with a broth rheology close to Newtonian flow behavior.Article Citation - WoS: 30Citation - Scopus: 42Effect of Various Process Parameters on Morphology, Rheology, and Polygalacturonase Production by Aspergillus Sojae in a Batch Bioreactor(American Institute of Chemical Engineers, 2007) Öncü, Şelale; Tarı, Canan; Ünlütürk, SevcanThe effects of pH, agitation speed, and dissolved oxygen tension (DOT), significant in common fungal fermentations, on the production of polygalacturonase (PG) enzyme and their relation to morphology and broth rheology were investigated using Aspergillus sojae in a batch bioreactor. All three factors were effective on the response parameters under study. An uncontrolled pH increased biomass and PG activity by 27% and 38%, respectively, compared to controlled pH (pH 6) with an average pellet size of 1.69 ± 0.48 mm. pH did not significantly affect the broth rheology but created an impact on the pellet morphology. Similarly, at constant agitation speed the maximum biomass obtained at 500 rpm and at 30 h was 3.27 and 3.67 times more than at 200 and 350 rpm, respectively, with an average pellet size of 1.08 ± 0.42 mm. The maximum enzyme productivity of 0.149 U mL-1 h-1 was obtained at 200 rpm with an average pellet size of 0.71 ± 0.35 mm. Non-Newtonian and pseudoplastic broth rheology was observed at 500 rpm agitation speed, broth rheology exhibited dilatant behavior at the lower agitation rate (200 rpm), and at the medium agitation speed (350 rpm) the broth was close to Newtonian. Furthermore, a DOT range of 30-50% was essential for maximum biomass formation, whereas only 10% DOT was required for maximum PG synthesis. Non-Newtonian shear thickening behavior (n > 1.0) was depicted at DOT levels of 10% and 30%, whereas non-Newtonian shear thinning behavior (n < 1.0) was dominant at 50% DOT. The overall fermentation duration (50-70 h) was considerably shorter compared to common fungal fermentations, revealing the economic feasibility of this particular process. As a result this study not only introduced a new strain with a potential of producing a highly commercially significant enzyme but also provided certain parameters significant in the design and mathematical modeling of fungal bioprocesses.