Food Engineering / Gıda Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/12
Browse
4 results
Search Results
Now showing 1 - 4 of 4
Article Citation - WoS: 51Citation - Scopus: 55Kinetic Modelling of Lactic Acid Production From Whey by Lactobacillus Casei (nrrl B-441)(John Wiley and Sons Inc., 2006) Altıok, Duygu; Tokatlı, Figen; Harsa, Hayriye ŞebnemThe biomass growth, lactic acid production and lactose utilisation kinetics of lactic acid production from whey by Lactobacillus casei was studied. Batch fermentation experiments were performed at controlled pH and temperature with six different initial whey lactose concentrations (9-77 g dm-3) in a 3 dm3 working volume bioreactor. Biomass growth was well described by the logistic equation with a product inhibition term. In addition, biomass and product inhibition effects were defined with corresponding power terms, which enabled adjustment of the model for low- and high-substrate conditions. The Luedeking-Piret equation defined the product formation kinetics. Substrate consumption was explained by production rate and maintenance requirements. A maximum productivity of 2.5 g dm-3 h-1 was attained with an initial lactose concentration of 35.5 g dm-3.Article Citation - WoS: 40Citation - Scopus: 38Homofermentative Lactic Acid Bacteria of a Traditional Cheese, Comlek Peyniri From Cappadocia Region(Cambridge University Press, 2005) Bulut, Çisem; Güneş, Hatice; Okuklu, Burcu; Harsa, Hayriye Şebnem; Kılıç, Sevda; Çoban, Hatice S.; Yenidünya, Ali FazılComlek peyniri is a typical artisanal cheese in Central Anatolia. This type of cheese was made by using the indigenous lactic acid bacteria (LAB) flora of cow or ewes' milk. Majority of the samples were taken from fresh cheese because the aim was to isolate homofermentative LAB. Initially 661 microbial isolates were obtained from 17 cheese samples. Only 107 were found to be homofermentative LAB. These isolates were selected and identified by using both phenotypic and molecular methods. Phenotypic identification included curd formation from skim milk, catalase test, Gram staining and light microscopy, growth at different temperatures and salt concentrations, arginine hydrolysis, gas production from glucose, and carbohydrate fermentation. Molecular identification was based on the polymerase chain reaction-restriction fragment length polymorphism (PCR-RFLP) of the 16S rRNA gene-ITS (internally transcribed spacer) region. By combining the phenotypic and molecular identification results, isolates belonging to each of the following genera were determined at species or subspecies level: 54 Lactococcus lactis subsp. lactis, 21 Enterococcus faecium, 3 Ec. faecalis, 2 Ec. durans, 10 Ec. sp., 15 Lactobacillus paracasei subsp. paracasei, and 2 Lb. casei strains. Technological characterisation was also performed by culturing each of the strains in UHT skim milk, and by monitoring pH change and lactic acid production at certain time intervals through the 24 h incubation. Results of the technological characterisation indicated that 33% of the isolates (35 strains) were capable of lowering the pH of UHT milk below 5.3 after 6 h incubation at 30°C. Thirty four of these strains were Lc. lactis subsp. lactis, and only one was an Ec. faecium strain.Article Citation - WoS: 29Citation - Scopus: 32Optimization of Lactic Acid Production From Whey by L Casei Nrrl B-441 Immobilized in Chitosan Stabilized Ca-Alginate Beads(John Wiley and Sons Inc., 2005) Göksungur, Mehmet Yekta; Gündüz, Meltem; Harsa, Hayriye ŞebnemThe production of lactic acid from whey by Lactobacillus casei NRRL B-441 immobilized in chitosan-stabilized Ca-alginate beads was investigated. Higher lactic acid production and lower cell leakage were observed with alginate-chitosan beads compared with Ca-alginate beads. The highest lactic acid concentration (131.2 g dm-3) was obtained with cells entrapped in 1.3-1.7 mm alginate-chitosan beads prepared from 2% (w/v) Na-alginate. The gel beads produced lactic acid for five consecutive batch fermentations without marked activity loss and deformation. Response surface methodology was used to investigate the effects of three fermentation parameters (initial sugar, yeast extract and calcium carbonate concentrations) on the concentration of lactic acid. Results of the statistical analysis showed that the fit of the model was good in all cases. Initial sugar, yeast extract and calcium carbonate concentrations had a strong linear effect on lactic acid production. The maximum lactic acid concentration of 136.3 g dm-3 was obtained at the optimum concentrations of process variables (initial sugar 147.35 g dm-3, yeast extract 28.81 g dm-3, CaCO3 97.55 g dm-3). These values were obtained by fitting of the experimental data to the model equation. The response surface methodology was found to be useful in optimizing and determining the interactions among process variables in lactic acid production using alginate-chitosan-immobilized cells.Article Citation - WoS: 72Citation - Scopus: 83Batch Production of L(+) Lactic Acid From Whey by Lactobacillus Casei (nrrl B-441)(John Wiley and Sons Inc., 2004) Büyükkileci, Ali Oğuz; Harsa, Hayriye ŞebnemThe effects of temperature, pH, and medium composition on lactic acid production by Lactobacillus casei were investigated. The highest lactic acid productivity values were obtained at 37 °C and pH 5.5. The productivity was 1.87 g dm-3 h-1 at 37 °C in shake flasks. In the fermenter, a productivity of 3.97 g dm-3 h-1 was obtained at pH 5.5. The most appropriate yeast extract concentration was 5.0 g dm-3. Whey yielded a higher productivity value than the analytical lactose and glucose. Initial whey lactose concentration did not affect lactic acid productivity. MnSO4·H2O was necessary for lactic acid production by L casei from whey. Product yields were approximately 0.93 g lactic acid g lactose-1.