Food Engineering / Gıda Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/12
Browse
2 results
Search Results
Now showing 1 - 2 of 2
Article Citation - WoS: 7Citation - Scopus: 7Effect of Process Parameters and Microparticle Addition on Polygalacturonase Activity and Fungal Morphology of Aspergillus Sojae(Springer, 2022) Germeç, Mustafa; Karahalil, Ercan; Yatmaz, Ercan; Tarı, CananIn this study, the effects of process parameters (initial glucose concentrations, inoculation rates, and nitrogen sources including yeast extract, beef extract, and ammonium nitrate instead of peptone) on polygalacturonase production by Aspergillus sojae in the shaking incubator were examined. Subsequently, the effect of talcum microparticles on activity and morphology was investigated. Based on the results, the highest activity and lowest pellet diameter were 41.91 U/mL and 1411.9 µm when initial glucose concentration and inoculation size were 20 g/L and 12% (v/v), respectively. Besides, as inoculation rate increased, maximum specific growth rate and saturation constant decreased from 0.39 to 0.27 day−1 and 21.26 to 3.50 g/L, respectively. It was determined that highest activity and lowest pellet diameter were found as 18.53 U/mL and 2953.0 µm when medium was supplemented with 2.5 g/L yeast extract. It was also found that as yeast extract and beef extract concentrations increased, pellet diameter decreased. Additionally, medium was supplemented with talcum as a microparticle (0–25 g/L), and maximum activity was 26.59 U/mL (pellet diameter was 2756.3 µm) when talcum concentration was 5 g/L. In addition, as talcum concentration increases from 0.1 to 5 g/L, the biomass concentration increased relatively, but the enzyme activity increased significantly. However, although talcum concentration in the medium is increased until 20 g/L, while the biomass concentration increased, the activity decreased. Compared to control fermentation (without talcum), the activity increased ninefold. Polygalacturonase was also partially purified via ultrafiltration with the purification fold of 1.84. Consequently, fungal morphology in submerged fermentation can be controlled by microparticle addition fermentation, and thus the enzyme activity can be increased.Article Citation - WoS: 18Citation - Scopus: 35Microparticle-Enhanced Polygalacturonase Production by Wild Type Aspergillus Sojae(Springer Verlag, 2017) Karahalil, Ercan; Demirel, Fadime; Evcan, Ezgi; Germeç, Mustafa; Tarı, Canan; Turhan, İrfanPolygalacturonases (PGs), an important industrial enzyme group classified under depolymerases, catalyze the hydrolytic cleavage of the polygalacturonic acid chain through the introduction of water across the oxygen bridge. In order to produce and increase the concentration of this enzyme group in fermentation processes, a new approach called microparticle cultivation, a promising and remarkable method, has been used. The aim of this study was to increase the PG activity of Aspergillus sojae using aluminum oxide (Al2O3) as microparticles in shake flask fermentation medium. Results indicated that the highest PG activity of 34.55 ± 0.5 U/ml was achieved with the addition of 20 g/L of Al2O3 while the lowest activity of 15.20 ± 0.2 U/mL was obtained in the presence of 0.1 g/L of Al2O3. In fermentation without microparticles as control, the activity was 15.64 ± 3.3 U/mL. Results showed that the maximum PG activity was 2.2-fold higher than control. Additionally, smaller pellets formed with the addition of Al2O3 where the lowest pellet diameter was 955.1 µm when 10 g/L of the microparticle was used. Also, it was noticed that biomass concentration gradually increased with increasing microparticle concentration in the fermentation media. Consequently, the PG activity was significantly increased in microparticle-enhanced shake flask fermentation. In fact, these promising preliminary data can be of significance to improve the enzyme activity in large-scale bioreactors.