Photonics / Fotonik
Permanent URI for this collectionhttps://hdl.handle.net/11147/2590
Browse
8 results
Search Results
Article Citation - WoS: 3Citation - Scopus: 4Experimental and First-Principles Investigation of Cr-Driven Color Change in Cesium Lead Halide Perovskites(American Institute of Physics, 2019) Özen, Sercan; Güner, Tuğrul; Topçu, Gökhan; Özcan, Mehmet; Demir, Mustafa Muammer; Şahin, HasanHerein, we report room temperature Cr-doping for all-inorganic perovskites that have attracted great attention in recent years due to their extraordinary optical properties, low cost, and ease of synthesis. Incorporation of Cr 3 + ions into the perovskite crystal lattices is achieved by following a facile route involving an antisolvent recrystallization method at room temperature. It is shown that both Cr-doping and formation of crystals in the CsPbBr x Cl 3 - x phase are provided by increasing the concentration of the CrCl 3 solution. It is also observed that the doping procedure leads to the emergence of three types of distinctive peaks in the PL spectrum originating from CsPbBr x Cl 3 - x domains (476-427nm), Cr-strained host lattices (515nm), and midgap states formed by Cr dopants (675-775nm). It is also found that the Cr-doped perovskites emitting a dark violaceous color change their color to white with a high color rendering index (88) in 30-day time intervals. Easy-tunable optical properties of all-inorganic Cs perovskites indicate their great potential for future optoelectronic device applications.Article Citation - WoS: 5Citation - Scopus: 6Contribution of O-2 Plasma Treatment and Amine Modified Gos on Film Properties of Conductive Pedot:pss: Application in Indium Tin Oxide Free Solution Processed Blue Oled(Elsevier, 2019) Diker, Halide; Yeşil, Fatih; Varlıklı, CananPrimary (n-propyl amine, n-PRYLA), secondary (dipropyl amine, DPRYLA) and alcohol (propanol amine, PRPOHA) amine derivatives were used as amine sources in graphene oxide (GO) modification and obtained samples were named as nPRYLA-GO, DPRYLA-GO and PRPOHA-GO, respectively. Modified graphene oxide (mGO) derivatives were doped in poly (3,4-ethylenedioxythiophene)-poly(styrenesulfonate) (PH1000) and O-2 plasma treatment (70W, 3 min) was applied on the spin casted films. PH1000:mGO films presented high optical transparency values (> 90%) and low resistivity (177-183 Q/sq). The roughness values were increased especially when the hydrophobic alkyl chain containing DPRYLA-GO and nPRYLA-GO were doped in PH1000. Prepared films were utilized as anode in solution processed blue organic light emitting diode. PH1000:PRPOHA-GO anode presented more than 30 nm of decrement in full with at half maximum and 1.6, 1.5 and 1.9 fold enhancements in current, power and external quantum efficiency values, compared to those of ITO anode, respectively.Article Citation - WoS: 89Citation - Scopus: 85Cspbbr3 Perovskites: Theoretical and Experimental Investigation on Water-Assisted Transition From Nanowire Formation To Degradation(American Physical Society, 2018) Akbalı, Barış; Topçu, Gökhan; Güner, Tuğrul; Özcan, Mehmet; Demir, Mustafa Muammer; Şahin, HasanRecent advances in colloidal synthesis methods have led to an increased research focus on halide perovskites. Due to the highly ionic crystal structure of perovskite materials, a stability issue pops up, especially against polar solvents such as water. In this study, we investigate water-driven structural evolution of CsPbBr3 by performing experiments and state-of-the-art first-principles calculations. It is seen that while an optical image shows the gradual degradation of the yellowish CsPbBr3 structure under daylight, UV illumination reveals that the degradation of crystals takes place in two steps: transition from a blue-emitting to green-emitting structure and and then a transition from a green-emitting phase to complete degradation. We found that as-synthesized CsPbBr3 nanowires (NWs) emit blue light under a 254 nm UV source. Before the degradation, first, CsPbBr3 NWs undergo a water-driven structural transition to form large bundles. It is also seen that formation of such bundles provides longer-term environmental stability. In addition theoretical calculations revealed the strength of the interaction of water molecules with ligands and surfaces of CsPbBr3 and provide an atomistic-level explanation to a transition from ligand-covered NWs to bundle formation. Further interaction of green-light-emitting bundles with water causes complete degradation of CsPbBr3 and the photoluminescence signal is entirely quenched. Moreover, Raman and x-ray-diffraction measurements revealed that completely degraded regions are decomposed to PbBr2 and CsBr precursors. We believe that the findings of this study may provide further insight into the degradation mechanism of CsPbBr3 perovskite by water.Article Citation - WoS: 18Citation - Scopus: 46Phosphor-Based White Led by Various Glassy Particles:control Over Luminous Efficiency(The Optical Society, 2019) Yüce, Hürriyet; Güner, Tuğrul; Balcı, Sinan; Demir, Mustafa MuammerGenerating white light through a mainstream remote phosphor design suffers from phosphor conversion efficiency loss due to a backscattering of light. Such a loss also reduces luminous efficiency of the resulting white light. To overcome this issue, various glassy scatterers with different morphologies such as glass bubbles, glass beads, and nanosized silica particles were employed as scatterers, together with a fixed amount of yellow phosphor (YAG:Ce3+) and a poly(dimethylsiloxane) (PDMS) matrix. In addition, the simulation of the system validates the rigorous multiple scattering of the incoming light most probably due to refractive index mismatch between the glass bubbles and surrounding PDMS matrix along with the internal reflections. (C) 2019 Optical Society of AmericaArticle Citation - WoS: 15Citation - Scopus: 16Monitoring the Crystal Orientation of Black-Arsenic Via Vibrational Spectra(Royal Society of Chemistry, 2019) Kandemir, Ali; İyikanat, Fadıl; Şahin, HasanIn this study, the structural, mechanical, and vibrational properties of a recently discovered anisotropic ultra-thin material, black-arsenic (b-As), are investigated by using density functional theory. Direction dependent elastic constants such as in-plane stiffness, Young's modulus and Poisson's ratio of single-layer b-As are calculated and compared with those of the structural cousin black-phosphorus (b-P). The calculated Poisson's ratio of b-As for the zigzag direction is nearly 1, which is quite higher than that of b-P, 0.65. Besides, it is found that all the three elastic constants are highly anisotropic and their values in the zigzag direction are almost three times higher than that of the armchair direction. The mechanical strength of the material is also calculated and high-toughness is seen in both armchair and zigzag directions. It is revealed that the material is quite stiff against straining along the zigzag direction; in contrast, it is quite flexible along the armchair direction. Vibrational stability analysis shows that the material is stable up to 9% biaxially applied strain, and 12% and 45% uniaxially applied strain in the zigzag and armchair directions, respectively. Furthermore, the prominent Raman active peaks of the b-As structure show strong anisotropy in the strain dependent vibrational spectra and they can also be used for easy-determination of the crystal orientation of b-As from Raman measurements.Article Citation - WoS: 72Citation - Scopus: 77Gd3+-Doped Alpha-Cspbi3 Nanocrystals With Better Phase Stability and Optical Properties(American Chemical Society, 2019) Güvenç, Çetin Meriç; Yalçınkaya, Yenal; Özen, Sercan; Şahin, Hasan; Demir, Mustafa MuammerBlack alpha-CsPbI3 perovskites are unable to maintain their phase stability under room conditions; hence, the alpha-CsPbI3 phase transforms into a thermodynamically stable yellow delta-CsPbI3 phase within a few days, which has a nonperovskite structure and high band gap for optoelectronic applications. This phase transformation should be prevented or at least retarded to make use of superior properties of alpha-CsPbI3 in optoelectronic applications. In this study, Gd3+ doping was employed with the aim of increasing the stability of alpha-CsPbI3. All doped alpha-CsPbI3 nanocrystals with various levels of Gd3+, between 5 and 15 mol %, have shown greater phase stability than that of the pure alpha-CsPbI3 phase from 5 days up to 11 days under ambient conditions. This prolonged phase stability can be attributed to three potential reasons: increased tolerance factor of the perovskite structure, distorted cubic symmetry, and decreased defect density in nanocrystals. Urbach energy values suggest the reduction of defect density in the doped nanocrystals. Also, use of 10 mol % Gd3+ as a dopant material increases the photoluminescence quantum yield from 70 to 80% and fluorescence lifetime of alpha-CsPbI3 from 47.4 to 64.4 ns. Further, density functional theory calculations are in a good agreement with the experimental results.Article Citation - WoS: 35Citation - Scopus: 36Colloidal Nanodisk Shaped Plexcitonic Nanoparticles With Large Rabi Splitting Energies(American Chemical Society, 2019) Mert Balcı, Fadime; Sarısözen, Sema; Polat, Nahit; Balcı, SinanWhen plasmons supported by metal nanoparticles interact strongly with molecular excitons or excitons of semiconducting quantum dots, plexcitons are formed in the strong coupling regime. The hybrid plexcitonic nanoparticles with a wide range of sizes and shapes have been synthesized by using wet chemistry methods or have been fabricated on solid substrates by using lithographic techniques. In order to deeply understand plasmon-exciton interaction at the nanoscale dimension and boost the performance of nanophotonic devices made of plexcitonic nanoparticles, new types of plexcitonic nanoparticles with tunable optical properties and outstanding stability at room temperature are urgently needed. Herein, we for the first time report pure colloidal nanodisk shaped plexcitonic nanoparticles with very large Rabi splitting energies, i.e., more than 350 meV. We synthesize silver nanoprisms by using seed mediated synthesis and then convert nanoprisms to nanodisks at a high temperature. Localized plasmon resonance of the silver nanodisk in the visible spectrum can be effectively tuned by heating. Subsequently, self-assembly of J-aggregate dyes on plasmonic nanodisks produces plexcitonic nanoparticles. We envision that colloidal nanodisk shaped plexcitonic nanoparticles with very large Rabi splitting energies and outstanding stability at room temperature will enlarge the application of plexcitonic nanoparticles in a variety of fields such as polariton laser, biosensor, plasmon molecular nanodevices, and energy flow at nanoscale dimensions.Conference Object Reversible Energy Transfer Between a Single Defect in Hbn and Graphene(OSA - The Optical Society, 2019) Özçeri, Elif; Arı, Ozan; Balcı, Sinan; Kocabaş, Coşkun; Ateş, SerkanWe present a reversible energy transfer between a single defect in hBN and graphene. Dynamic control of Fermi level of graphene results in switching on and off single photon emission from a single quantum emitter. © OSA 2019 © 2019 The Author(s)