Photonics / Fotonik
Permanent URI for this collectionhttps://hdl.handle.net/11147/2590
Browse
7 results
Search Results
Article Citation - WoS: 9Citation - Scopus: 11Electrospun Polyacrylonitrile (pan)/Polypyrrole (ppy) Nanofiber-Coated Quartz Crystal Microbalance for Sensing Volatile Organic Compounds(Springer, 2023) Yağmurcukardeş, Nesli; İnce Yardımcı, Atike; Yağmurcukardeş, Mehmet; Çapan, İnci; Erdoğan, Matem; Çapan, Rifat; Açıkbaş, YaserIn this study, electrospun polyacrylonitrile (PAN)/polypyrrole (PPy) nanofibers (NFs) coated quartz crystal microbalance (QCM) were investigated for their sensing characteristics against six different volatile organic compounds (VOCs): chloroform, dichloromethane, carbon tetrachloride, benzene, toluene and xylene. SEM, TEM, FT-IR and TGA analysis were carried out for the characterization of PAN/PPy nanofibers and characterization results of PAN/PPy NFs showed that these nanofibers were morphologically well-arranged and straightforward with a cylindrical shape with the average fiber diameter of 253.17 +/- 27 nm. Among all the gas measurement tests, dichloromethane displayed the highest response values for PAN/PPy coated QCM sensors. When the reproducibility of kinetic studies for PAN/PPy NFs coated QCM sensors were examined, the most repetitive results were obtained by this QCM sensor during dichloromethane investigation and the diffusion coefficients of VOCs for the first and second regions increased with the order of xylene < toluene < benzene < carbontetrachloride < chloroform < dichloromethane. The sensitivities of the PAN/PPy nanofibers-coated QCM sensor against organic vapors are determined between 4.71 and 6.17 (Hz ppm(-1)) x 10(-4). As a result, PAN/PPy nanofibers exhibited high sensitivity and selectivity for VOCs sensor applications, especially for dichloromethane.Article Citation - WoS: 49Citation - Scopus: 54Highly Porous Poly(o-Phenylenediamine) Loaded Magnetic Carboxymethyl Cellulose Hybrid Beads for Removal of Two Model Textile Dyes(Springer, 2022) Arıca, Tuğçe Aybüke; Balcı, Fadime Mert; Balcı, Sinan; Arıca, Mehmet YakupEnsuring the removal of complex dyes from wastewater is a topic of great interest as it is vital for the environment. The present study reports a facile preparation method for poly(o-phenylenediamine) [p(o-PDA)] micro-particles loaded to magnetic carboxymethyl cellulose (CMC) hydrogel beads as adsorbents. The prepared products were characterized by FTIR, TGA, VSM, SEM, BET, and zeta sizer. The Fe3O4@p(o-PDA)@CMC beads were used for the removal of Reactive Blue 4 (RB-4) and Congo Red (CR) textile dyes from an aqueous medium. Different factors, such as adsorbent dose, initial pH, ionic strength, contact time, temperatures, and initial RB-4 and CR concentrations were examined. The maximum adsorption capacities of the RB-4 dye and CR at optimum pH 5 reached 398.7 and 524.6 mg/g in 120 min, respectively. The adsorption of RB-4 and CR on the hybrid magnetic beads can be due to the electrostatic, hydrogen bonding, and π-π interactions. Moreover, the magnetic hybrid beads showed easy regeneration ability and good reusability. The adsorbent can be a very good candidate for the efficient removal of micro-pollutant from wastewater.Article Citation - WoS: 17Citation - Scopus: 20Electrospun Polyacrylonitrile (pan) Nanofiber: Preparation, Experimental Characterization, Organic Vapor Sensing Ability and Theoretical Simulations of Binding Energies(Springer, 2022) İnce Yardımcı, Atike; Yağmurcukardeş, Nesli; Yağmurcukardeş, Mehmet; Çapan, İnci; Erdoğan, Matem; Çapan, Rıfat; Tarhan, Özgür; Açıkbaş, YaserIn this study, polyacrilonitrile (PAN) nanofibers obtained by electrospinning were directly coated on the surface of a quartz crystal microbalance (QCM) and were investigated for their sensing characteristics against chloroform, dichloromethane and carbon tetrachloride as volatile organic compounds (VOCs). PAN nanofibers were characterized by SEM, DSC, Raman Spectroscopy, and FT-IR and the results indicated that beadless and regular nanofibers with the average diameter of 182.7 ± 32 nm were obtained. Kinetic measurements indicated that electrospun PAN nanofibers were sensitive to the VOCs and they were appropriate for sensing applications of chlorine compounds. The reproducibility of PAN nanofiber sensor was also shown in this study. The results revealed that the diffusion coefficients of VOCs increased with the order carbontetrachloride < dichloromethane < chloroform which was supported by the density functional theory (DFT) simulations that revealed the highest binding energy for chloroform.Article Citation - WoS: 29Citation - Scopus: 28Fabrication, Illumination Dependent Electrical and Photovoltaic Properties of Au/Bod-pyr Schottky Diode(Springer, 2021) Ongun, Onur; Taşcı, Enis; Emrullahoğlu, Mustafa; Akın, Ummuhan; Tuğluoğlu, Nihat; Eymur, Serkan4,4-Difluoro-4-bora-3a,4a-diaza-s-indacene (BODIPY)-based BOD-Pyr compound was synthesized according to the literature and HOMO and LUMO energies of the BOD-Pyr were calculated by DFT/B3LYP/6-311G(d,p) method using on Gaussian 09 W. Au/BOD-Pyr/n-Si/In Schottky diode were fabricated using thermal evaporation and spin coating technique. The electronic and photovoltaic properties of Au/BOD-Pyr/n-Si/In diode have been investigated by current-voltage (I-V) measurements at dark and under various illumination intensities. The calculated ideality factor and barrier height of the diode in dark were found to be 2.84 and 0.75 eV, respectively. These parameters were also obtained under 100 mW/cm(2) illumination level as 1.55 and 0.87 eV, respectively. The values of open-circuit voltage and short circuit current density were obtained as 0.26 V and 0.56 mA/cm(2) under the illumination level of 100 mW/cm(2). These all findings suggest that Au/BOD-Pyr/n-Si/In diode can be used as photodiode in optoelectronic applications.Article Citation - WoS: 14Citation - Scopus: 14Analysis of Illumination Dependent Electrical Characteristics of Α- Styryl Substituted Bodipy Dye-Based Hybrid Heterojunction(Springer, 2021) Kaplan, Nazmiye; Taşcı, Enis; Emrullahoğlu, Mustafa; Gökçe, Halil; Tuğluoğlu, Nihat; Eymur, SerkanThe alpha-styryl substituted BODIPY compound (BDP-Sty) was synthesized and characterized. The optimize ground state structure, HOMO and LUMO simulations, MEP surface map, and various molecular descriptors of the isolated BDP-Sty compound were investigated by Density Functional Theory at the B3LYP/6-311G (d,p) level. The reverse and forward bias current-voltage (I-V) characteristics of the Au/BDP-Sty/n-Si/In diode showed Schottky diode-like characteristics. An ideality factor (n) and barrier height (phi(b)) values of prepared diode for dark were found as 2.32 and 0.828, respectively. The series resistance (R-s) values were attained from the dV/dln(I) plot and Cheung's H(I) function and their values found for dark as 4.95 k omega and 4.59 k omega, respectively. The lnI - lnV and ln(I-R) - V-R(1/2) characteristics of the Au/BDP-Sty/n-Si/In diode reveal that the conduction mechanism is ohmic at low voltage and that of trap-filled space charge limited current and space charge limited current at higher voltage. The characteristic photodiode parameters of the prepared diode such as open circuit voltage (V-oc), short circuit current density (J(sc)), and photosensitivity (S) have also been investigated. All these results indicate the applicability for Au/BDP-Sty/n-Si/In diode in the field optoelectronic device applications.Article Citation - WoS: 16Citation - Scopus: 16Investigation of Electrical and Photovoltaic Properties of Au/N-si Schottky Diode With Bod-Z Interlayer(Springer, 2021) Tezcan, Ali Osman; Eymur, Serkan; Taşcı, Enis; Emrullahoğlu, Mustafa; Tuğluoğlu, Nihat4,4-Difluoro-4-bora-3a,4a-diaza-s-indacene (BODIPY) based BOD-Z-EN compound was used as an interfacial organic layer to fabrication of Au/BOD-Z-EN/n-Si/In diode. The electrical parameters of Au/BOD-Z-EN/n-Si/In diode such as ideality factor (n), barrier height (phi(b)) and series resistance (R-s) have been investigated through current-voltage (I-V) studies at dark and under various illumination intensities to understand the effect of interlayer on the device properties. The values found for the n varied from 2.33 to 1.55 and the phi(b) ranged from 0.86 to 0.90 eV as the illumination condition changed from dark to 100 mW/cm(2). Series resistance (R-s) values calculated using Cheung's method were found to decrease with increasing illumination level. The forward bias I-V characteristics of the diode were explained by the space charge limited current theory. The main photovoltaic parameters such as open circuit voltage (V-oc), short circuit current density (J(sc)) and fill factor (FF) were determined for various light intensity. The Au/BOD-Z-EN/n-Si/In diode exhibits a photovoltaic behavior with a V-oc of 150 mV and J(sc) of 10 mu A/cm(2) under 100 mw/cm(2). In addition, photosensitivity and photoresponsivity properties of the diode were determined. All these results indicate that Au/BOD-Z-EN/n-Si/In device can be used as photosensor in optoelectronic applications.Correction Citation - Scopus: 1Erratum To: Introduction To the Physics of Silicene and Other 2d Materials(Springer, 2017) Cahangirov, Seymur; Şahin, Hasan; Le Lay, Guy; Rubio, Angel[No abstract available]