Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
12 results
Search Results
Article Citation - WoS: 96Citation - Scopus: 105Comparative Study of a Building Energy Performance Software (kep-Iyte and Ann-Based Building Heat Load Estimation(Elsevier Ltd., 2014) Turhan, Cihan; Kazanasmaz, Zehra Tuğçe; Erlalelitepe Uygun, İlknur; Ekmen, Kenan Evren; Gökçen Akkurt, GüldenThe several parameters affect the heat load of a building; geometry, construction, layout, climate and the users. These parameters are complex and interrelated. Comprehensive models are needed to understand relationships among the parameters that can handle non-linearities. The aim of this study is to predict heat load of existing buildings benefiting from width/length ratio, wall overall heat transfer coefficient, area/volume ratio, total external surface area, total window area/total external surface area ratio by using artificial neural networks and compare the results with a building energy simulation tool called KEP-IYTE-ESS developed by Izmir Institute of Technology. A back propagation neural network algorithm has been preferred and both simulation tools were applied to 148 residential buildings selected from 3 municipalities of Izmir-Turkey. Under the given conditions, a good coherence was observed between artificial neural network and building energy simulation tool results with a mean absolute percentage error of 5.06% and successful prediction rate of 0.977. The advantages of ANN model over the energy simulation software are observed as the simplicity, the speed of calculation and learning from the limited data sets.Article Citation - WoS: 37Citation - Scopus: 38Prediction of the Bottom Ash Formed in a Coal-Fired Power Plant Using Artificial Neural Networks(Elsevier Ltd., 2012) Bekat, Tuğçe; Erdoğan, Muharrem; İnal, Fikret; Genç, Aytenhe amount of bottom ash formed in a pulverized coal-fired power plant was predicted by artificial neural network modeling using one-year operating data of the plant and the properties of the coals processed. The model output was defined as the ratio of amount of bottom ash produced to amount of coal burned (Bottom ash/Coal burned). The input parameters were the moisture contents, ash contents and lower heating values of the coals. The total 653 data were divided into two groups for the training (90% of the data) and the testing (10% of the data) of the network. A three-layer, feed-forward type network architecture with back-propagation learning was used in the modeling study. The activation function was sigmoid function. The best prediction performance was obtained for a one hidden layer network with 29 neurons. The learning rate and the tolerance value were 0.2 and 0.05, respectively. R2 (coefficient of determination) values between the actual (Bottom ash/Coal burned) ratios and the model predictions were 0.988 for the training set and 0.984 for the testing set. In addition, the sensitivity analysis indicated that the ash content of coals was the most effective parameter for the prediction of the ratio of bottom ash to coal burned.Article Citation - WoS: 4Citation - Scopus: 5Biophysical and Microbiological Study of High Hydrostatic Pressure Inactivation of Bovine Viral Diarrheavirus Type 1 on Serum(Elsevier Ltd., 2012) Ceylan, Çağatay; Severcan, Feride; Özkul, Aykut; Severcan, Mete; Bozoğlu, Faruk; Taheri, NusretThe effect of high hydrostatic pressure application on fetal bovine serum components and the model microorganism (Bovine Viral Diarrheavirus type 1 NADL strain) was studied at 132 and 220MPa pressure for 5min at 25°C. Protein secondary structures were found to be unaffected by an artificial neural network application on the amide I region for both untreated and HHP treated samples. FTIR spectroscopy study of both the HHP-treated and control samples revealed changes in the intensity of some bands in the finger-print region (1500-900cm -1) originating mainly from lipids which are thought to result from changes in the lipoprotein structure. The virus strain lost its infectivity completely after 220MPa HHP treatments. These results indicate that HHP can be successfully used for inactivation of pestiviruses while leaving structural and functional properties of serum and serum products unaffected. © 2011 Elsevier B.V.Article Citation - WoS: 91Citation - Scopus: 122Artificial Neural Networks To Predict Daylight Illuminance in Office Buildings(Elsevier Ltd., 2009) Kazanasmaz, Zehra Tuğçe; Günaydın, Hüsnü Murat; Binol, SelcenA prediction model was developed to determine daylight illuminance for the office buildings by using artificial neural networks (ANNs). Illuminance data were collected for 3 months by applying a field measuring method. Utilizing weather data from the local weather station and building parameters from the architectural drawings, a three-layer ANN model of feed-forward type (with one output node) was constructed. Two variables for time (date, hour), 5 weather determinants (outdoor temperature, solar radiation, humidity, UV index and UV dose) and 6 building parameters (distance to windows, number of windows, orientation of rooms, floor identification, room dimensions and point identification) were considered as input variables. Illuminance was used as the output variable. In ANN modeling, the data were divided into two groups; the first 80 of these data sets were used for training and the remaining 20 for testing. Microsoft Excel Solver used simplex optimization method for the optimal weights. The model's performance was then measured by using the illuminance percentage error. As the prediction power of the model was almost 98%, predicted data had close matches with the measured data. The prediction results were successful within the sample measurements. The model was then subjected to sensitivity analysis to determine the relationship between the input and output variables. NeuroSolutions Software by NeuroDimensions Inc., was adopted for this application. Researchers and designers will benefit from this model in daylighting performance assessment of buildings by making predictions and comparisons and in the daylighting design process by determining illuminance.Article Citation - WoS: 11Citation - Scopus: 18Ann Model for Prediction of Powder Packing(Elsevier Ltd., 2007) Sütçü, Mücahit; Akkurt, SedatA multilayer feed forward backpropagation (MFFB) learning algorithm was used as an artificial neural network (ANN) tool to predict packing of fused alumina powder mixtures of three different sizes in green state. The data used in model construction were collected by mixing and pressing powders with average particle sizes of 350, 30 and 3 μm and with narrow particle size distributions. The data sets that were composed of green densities of cylindrical pellets were first randomly partitioned into two for training and testing of the ANN models. Based on the training data an ANN model of the packing efficiencies was created with low average error levels (3.36%). Testing of the model was also performed with successfully good average error levels of 3.39%.Article Citation - WoS: 121Citation - Scopus: 136Quantification of Caco3-Caso3·0.5h 2o-Caso4·2h2o Mixtures by Ftir Analysis and Its Ann Model(Elsevier Ltd., 2004) Böke, Hasan; Akkurt, Sedat; Özdemir, Serhan; Göktürk, E. Hale; Caner Saltık, Emine N.A new quantitative analysis method for mixtures of calcium carbonate (CaCO3), calcium sulphite hemihydrate (CaSO 3·1/2H2O) and gypsum (CaSO 4·2H2O) by FTIR spectroscopy is developed. The method involves the FTIR analysis of powder mixtures of several compositions on KBr disc specimens. Intensities of the resulting absorbance peaks for CaCO 3, CaSO3·1/2H2O and CaSO 4·2H2O at 1453, 980, 1146 cm-1 were used as input data for an artificial neural network (ANN) model, the output being the weight percent compositions of the mixtures. The training and testing data were randomly separated from the complete original data set. Testing of the model was done with successfully low-average error levels. The utility of the model is in the potential ability to use FTIR spectrum to predict the proportions of the three substances in unknown mixtures.Article Citation - Scopus: 33Modeling Freight Distribution Using Artificial Neural Networks(Elsevier Ltd., 2004) Çelik, Hüseyin MuratStudies about freight distribution modeling are limited due to the limitations in data availability. Existing studies in this subject, generally either use the conventional gravity models or the regression based models as modeling techniques. The present study, using the 1993 US Commodity Flow Survey Data, models inter-regional commodity flows for 48 continental states of the US with three different artificial neural networks (ANN). The results are compared with those of Celik and Guldmann's (2002) Box-Cox Regression Model. The ANN using conventional gravity model variables provides a slight improvement with respect to this Box-Cox model. However, the ANNs using theoretically relevant variables provide surprising improvements in comparison to the Box-Cox model. It is concluded that ANN architecture is a very promising technique for predicting short-term inter-regional commodity flows.Article Citation - WoS: 175Citation - Scopus: 203Fuzzy Logic Model for the Prediction of Cement Compressive Strength(Elsevier Ltd., 2004) Akkurt, Sedat; Tayfur, Gökmen; Can, SeverA fuzzy logic prediction model for the 28-day compressive strength of cement mortar under standard curing conditions was created. Data collected from a cement plant were used in the model construction and testing. The input variables of alkali, Blaine, SO3, and C3S and the output variable of 28-day cement strength were fuzzified by the use of artificial neural networks (ANNs), and triangular membership functions were employed for the fuzzy subsets. The Mamdani fuzzy rules relating the input variables to the output variable were created by the ANN model and were laid out in the If-Then format. Product (prod) inference operator and the centre of gravity (COG; centroid) defuzzification methods were employed. The prediction of 50 sets of the 28-day cement strength data by the developed fuzzy model was quite satisfactory. The average percentage error levels in the fuzzy model were successfully low (2.69%). The model was compared with the ANN model for its error levels and ease of application. The results indicated that through the application of fuzzy logic algorithm, a more user friendly and more explicit model than the ANNs could be produced within successfully low error margins.Article Citation - WoS: 135Citation - Scopus: 157The Use of Ga-Anns in the Modelling of Compressive Strength of Cement Mortar(Elsevier Ltd., 2003) Akkurt, Sedat; Özdemir, Serhan; Tayfur, Gökmen; Akyol, BurakIn this paper, results of a project aimed at modelling the compressive strength of cement mortar under standard curing conditions are reported. Plant data were collected for 6 months for the chemical and physical properties of the cement that were used in model construction and testing. The training and testing data were separated from the complete original data set by the use of genetic algorithms (GAs). A GA-artificial neural network (ANN) model based on the training data of the cement strength was created. Testing of the model was also done within low average error levels (2.24%). The model was subjected to sensitivity analysis to predict the response of the system to different values of the factors affecting the strength. The plots obtained after sensitivity analysis indicated that increasing the amount of C3S, SO3 and surface area led to increased strength within the limits of the model. C2S decreased the strength whereas C3A decreased or increased the strength depending on the SO3 level. Because of the limited data range used for training, the prediction results were good only within the same range. The utility of the model is in the potential ability to control processing parameters to yield the desired strength levels and in providing information regarding the most favourable experimental conditions to obtain maximum compressive strength.Article Citation - WoS: 11Citation - Scopus: 13Experimental and Artificial Neural Network Modeling Study on Soot Formation in Premixed Hydrocarbon Flames(Elsevier Ltd., 2003) İnal, Fikret; Tayfur, Gökmen; Melton, Tyler R.; Senkan, Selim M.The formation of soot in premixed flames of methane, ethane, propane, and butane was studied at three different equivalence ratios. Soot particle sizes, number densities, and volume fractions were determined using classical light scattering measurement techniques. The experimental data revealed that the soot properties were sensitive to the fuel type and combustion parameter equivalence ratio. Increase in equivalence ratio increased the amount of soot formed for each fuel. In addition, methane flames showed larger particle diameters at higher distances above the burner surface and propane, ethane, and butane flames came after the methane flames, respectively. Three-layer, feed-forward type artificial neural networks having seven input neurons, one output neuron, and five hidden neurons for soot particle diameter predictions and seven hidden neurons for volume fraction predictions were used to model the soot properties. The network could not be trained and tested with sufficient accuracy to predict the number density due to a large data range and greater uncertainty in determination of this parameter. The number of complete data set used in the model was 156. There was a good agreement between the experimental and predicted values, and neural networks performed better when predicting output parameters (i.e. soot particle diameters and volume fractions) within the limits of the training data.