Scopus İndeksli Yayınlar Koleksiyonu / Scopus Indexed Publications Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7148
Browse
10 results
Search Results
Now showing 1 - 10 of 10
Article Citation - WoS: 6Citation - Scopus: 6Experimental and Density Functional Theory Study on Humidity Sensing Properties of Copper Phthalocyanine (cupc)(IOP Publishing, 2019) Farzaneh, Amir; Esrafili, Mehdi D.; Okur, SalihThe quartz crystal microbalance (QCM) technique was applied to investigate humidity sensing properties of a copper phthalocyanine (CuPc) thin film prepared by drop cast method. The humidity adsorption and desorption kinetics of (CuPc) thin film was evaluated. The QCM and electrical measurements results showed that humidity sensing properties of CuPc is very sensitive to humidity changes and reversible adsorption/desorption performance which is an indicative of a good humidity sensor even at room temperature. Reproducible experimental results indicated that CuPc thin films have an abundant potential for humidity sensing applications at ambient temperature. According to the first-principle density functional theory calculations, the promising humidity sensing properties of CuPc can be attributed to the considerable charge transfer from the water molecule into Cu atom.Article Citation - WoS: 5Citation - Scopus: 4The Effect of Annealing Temperature on the Optical Properties of a Ruthenium Complex Thin Film(Elsevier Ltd., 2016) Ocakoğlu, Kasım; Okur, Salih; Aydın, Hasan; Emen, Fatih MehmetThe stability of the optical parameters of a ruthenium polypyridyl complex (Ru-PC K314) film under varying annealing temperatures between 278 K and 673 K was investigated. The ruthenium polypyridyl complex thin film was prepared on a quartz substrate by drop casting technique. The transmission of the film was recorded by using Ultraviolet/Visible/Near Infrared spectrophotometer and the optical band gap energy of the as-deposited film was determined around 2.20 eV. The optical parameters such as refractive index, extinction coefficient, and dielectric constant of the film were determined and the annealing effect on these parameters was investigated. The results show that Ru PC K314 film is quite stable up to 595 K, and the rate of the optical band gap energy change was found to be 5.23 × 10- 5 eV/K. Furthermore, the thermal analysis studies were carried out in the range 298-673 K. The Differential Thermal Analysis/Thermal Gravimmetry/Differantial Thermal Gravimmetry curves show that the decomposition is incomplete in the temperature range 298-673 K. Ru-PC K314 is thermally stable up to 387 K. The decomposition starts at 387 K with elimination of functional groups such as CO2, CO molecules and SO3H group was eliminated between 614 K and 666 K.Article Citation - WoS: 4Citation - Scopus: 4Effect of Aromatic Sams Molecules on Graphene/Silicon Schottky Diode Performance(Electrochemical Society, Inc., 2016) Yağmurcukardeş, Nesli; Aydın, Hasan; Can, Mustafa; Yanılmaz, Alper; Mermer, Ömer; Okur, Salih; Selamet, YusufAu/n-Si/Graphene/Au Schottky diodes were fabricated by transferring atmospheric pressure chemical vapor deposited (APCVD) graphene on silicon substrates. Graphene/n-Si interface properties were improved by using 5-[(3-methylphenyl)(phenyl) amino]isophthalic acid (MePIFA) and 5-(diphenyl)amino]isophthalic acid (DPIFA) aromatic self-assembled monolayer (SAM) molecules. The surface morphologies of modified and non-modified films were investigated by atomic force microscopy and scanning electron microscopy. The surface potential characteristics were obtained by Kelvin-probe force microscopy and found as 0.158 V, 0.188 V and 0,383 V as a result of SAMs modification. The ideality factors of n-Si/Graphene, n-Si/MePIFA/Graphene and n-Si/DPIFA/Graphene diodes were found as 1.07, 1.13 and 1.15, respectively. Due to the chain length of aromatic organic MePIFA and DPIFA molecules, also the barrier height φB values of the devices were decreased. While the barrier height of n-Si/Graphene diode was obtained as 0.931 eV, n-Si/MePIFA/Graphene and n-Si/DPIFA/Graphene diodes have barrier height of 0.820 and 0.720 eV, respectively.Article Citation - WoS: 31Citation - Scopus: 40Structural and Magnetic Characterization of Plasma Ion Nitrided Layer on 316l Stainless Steel Alloy(Elsevier Ltd., 2009) Öztürk, Orhan; Okur, Salih; Riviere, Jean PaulIn this study, an FeCrNi alloy (316L stainless steel disc) was nitrided in a low-pressure R.F. plasma at 430 °C for 72 min under a gas mixture of 60% N2-40% H2. Structural, compositional and magnetic properties of the plasma nitrided layer was investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM), atomic force microscopy (AFM) and magnetic force microscopy (MFM). The magnetic behaviour of the nitrided layer was also investigated with a vibrating sample magnetometer (VSM). Combined X-ray diffraction, cross-sectional SEM, AFM and MFM, as well as VSM analyses provide strong evidence for the formation of the γN phase, [γN-(Fe, Cr, Ni)], with mainly ferromagnetic characteristics. The uniform nature of the γN layer is clearly demonstrated by the XRD, cross-sectional SEM and AFM analyses. Based on the AFM and SEM data, the thickness of the γN layer is found to be ∼6 μm. According to the MFM and VSM analyses, ferromagnetism in the γN layer is revealed by the observation of stripe domain structures and the hysteresis loops. The cross-sectional MFM results demonstrate the ferromagnetic γN phase distributed across the plasma nitrided layer. The MFM images show variation in the size and form of the magnetic domains from one grain to another.Article Citation - WoS: 38Citation - Scopus: 42Layered Clay/Epoxy Nanocomposites: Thermomechanical, Flame Retardancy, and Optical Properties(John Wiley and Sons Inc., 2008) Kaya, Elçin; Tanoğlu, Metin; Okur, SalihIn this study, layered clay/polymer nano-composites were developed based on epoxy resins and montmorillonite as the nanoplatelet reinforcement. Clay particles were treated with hexadecyltrimethylammonium chloride (HTCA) through an ion exchange reaction. In this way, Na+ interlay er cations of the clay is exchanged with onium cation of the surfactant that turns the hydrophilic clays (MMT) to organophilic (OMMT) characteristics. Thermal analysis results revealed that the glass transition temperature (Tg) and the dynamic mechanical properties including the storage and loss modulus of the neat epoxy resin increases by the incorporation of clay particles. It was also found that flame resistance of the polymer is improved by the addition of the clay particles.Conference Object Citation - WoS: 6Citation - Scopus: 9Sub-Bandgap Optical Absorption Spectroscopy of Hydrogenated Microcrystalline Silicon Thin Films Prepared Using Hot-Wire Cvd (cat-Cvd) Process(Elsevier Ltd., 2006) Göktaş, Oktay; Işık, Nebile; Okur, Salih; Güneş, Mehmet; Carius, Reinhard; Klomfaß, Josef; Finger, FriedhelmHydrogenated microcrystalline silicon (μc-Si:H) thin films with different silane concentration (SC) have been prepared using the HW-CVD technique. Dual beam photoconductivity (DBP), photothermal deflection spectroscopy (PDS), and transmission measurements have been used to investigate the optical properties of the μc-Si:H films. Two different sub-bandgap absorption, α(hν), methods have been applied and analyzed to obtain a better insight into the electronic states involved. A good agreement has been obtained in the absorption spectrum obtained from the PDS and DBP measurements at energies above the bandgap. Differences between PDS and DBP spectra exist below the bandgap energy where DBP spectra always give lower α(hν) values and show a dependence on the SC. For some films, differences exist in the α(hν) spectra when the DBP measurements are carried out through the film and substrate side. In addition, for some films, there remains fringe pattern left on the spectrum after the calculation of the fringe-free absorption spectrum, which indicates structural inhomogeneities present throughout the film.Conference Object Citation - WoS: 8Citation - Scopus: 9Diffusion Length Measurements of Microcrystalline Silicon Thin Films Prepared by Hot-wire/Catalytic Chemical Vapor Deposition (hwcvd)(Elsevier Ltd., 2006) Okur, Salih; Güneş, Mehmet; Finger, Friedhelm; Carius, ReinhardHydrogenated microcrystalline silicon (μc-Si:H) films prepared by using the hot-wire/catalytic chemical vapor deposition (HWCVD) technique at low substrate temperatures between 185 °C and 220 °C with different silane concentrations (SC) were investigated using steady-state photocarrier grating (SSPG) and the steady-state photoconductivity methods (SSPC). Crystalline volume fractions (IC RS) obtained from Raman spectroscopy change from 0.22 to 0.77. The diffusion length (LD) is measured at generation rates between G = 1019 and 1021 cm- 3 s- 1. LD changes from 27 nm to 270 nm, with maximum values around SC = 5%. The dependence of LD on SC is similar to that observed for similar quality microcrystalline silicon films prepared using the VHF-PECVD technique. The grating quality factor, γ0, drops from about 0.9 to 0.5 after transition to the microcrystalline regime as indication of scattering from surface patterns.Conference Object Citation - WoS: 3Citation - Scopus: 3Low-Field Behavior of Ti-Added Mgb2/Cu Superconducting Wires(Institute of Electrical and Electronics Engineers Inc., 2005) Gençer, Ali; Kılıç, Ahmet; Okur, Salih; Güçlü, Nusret; Özyüzer, Lütfi; Belenli, İbrahimWe report on low-field magnetic properties of Ti-added (0-20 wt.% of Ti) Cu-clad MgB2 superconducting wires. Wires were produced by mixing appropriate amount of Ti and reacted MgB2 powder which was then placed inside Cu tubes with a diameter of 6 mm. The tubes were then cold worked by rolling or drawing to smaller diameters and then annealed at various temperatures to enhance the grain connectivity. XRD studies show that Ti addition results in new but minor phases. We have then measured ac susceptibilities in the temperature range between 20 K and 40 K in ac fields of 20-1600 A/m. The data show that an additional loss mechanism is established with Ti-addition. The calculated ac losses are increasing with increasing Ti-content in the main superconducting matrix.Article Citation - WoS: 49Citation - Scopus: 51Voc Sensors Based on a Metal Oxide Nanofibrous Membrane/Qcm System Prepared by Electrospinning(Royal Society of Chemistry, 2014) Horzum Polat, Nesrin; Taşçıoğlu, Didem; Özbek, Cebrail; Okur, Salih; Demir, Mustafa MuammerWe report a simple synthetic route to fabricate crystalline ZnO and CeO2/ZnO nanofibrous mats and their sensing characteristics against volatile organic compounds (VOCs) such as benzene, propanol, ethanol, and dichloromethane. Precursor fibers were fabricated by electrospinning of poly(vinyl alcohol) and metal salt(s) at 2.5 kV cm-1 in aqueous solution. The fibers were directly deposited on the crystal surface of a quartz crystal microbalance (QCM). The crystal, which was coated by nanostructured PVA/metal precursor(s) fibers, was subjected to calcination in air at 500 °C for 5 h. The formation of an oxide based nanofiber mat was revealed by scanning electron microscopy and X-ray diffraction. Upon exposure of the nanofiber mats to the VOCs, the compounds adsorbed onto the surface of oxidic fibers. The physisorption of the compounds was confirmed by FTIR and QCM. Both systems showed sensitivity to the VOCs and they hold a broad promise particularly for sensing applications of volatile alcoholic compounds. The introduction of CeO2 into the ZnO structure reduced the sensitivity of ZnO most probably due to the decrement of oxygen vacancies.Article Citation - WoS: 1Citation - Scopus: 1Modification of Al-Oxide Tunnel Barriers With Organic Self-Assembled Monolayers(American Institute of Physics, 1999) Okur, Salih; Zasadzinski, John F.Al-oxide tunneling barriers were modified by exposure to a vapor of n-octadecyltrimethoxysilane which forms self-assembled monolayers. The dynamic conductance dI/dV of the modified Al-oxide barrier between Al and Pb electrodes was measured at 4.2 K. Quasilinear conductance backgrounds are observed up to 200 mV with a strength that increases with increasing exposure time from 10 to 60 min. A saturation effect is observed around 200 mV. Beyond 200 mV the dynamic conductance shows a parabolic behavior indicative of elastic tunneling from an asymmetric barrier. The linear background is attributed to inelastic tunneling from a continuum of excitations