Chemical Engineering / Kimya Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/14
Browse
8 results
Search Results
Article Citation - WoS: 50Citation - Scopus: 54Isomerization of ?-Pinene Over Calcined Natural Zeolites(Elsevier Ltd., 2004) Akpolat, Oğuz; Gündüz, Gönül; Özkan, Fehime; Beşün, NurgünIn this work, isomerization reaction of α-pinene was studied over several heat-treated natural zeolite catalysts, rich in clinoptilolite, from Balýkesir-Bigadic region in Turkey in a batch slurry reactor under nitrogen atmosphere. Zeolite samples were calcined at different temperatures such as 300, 450 and 600°C. All catalysts were tested in the isomerization reaction of α-pinene and were characterised by nitrogen adsorption experiments, IR, and XRD measurements. Acidity strength and the distribution of Lewis and Bronsted acid sites of the samples were determined. Selectivities to main reaction products, camphene and limonene, and reaction kinetics were investigated. Catalytic activity, that is total conversion of α-pinene, of heat-treated samples decreased with increasing calcination temperatures. Selectivity to limonene is dependent on α-pinene conversion at high conversion levels while the selectivity to camphene is not. The formation of heavy products increased with treatment temperature. It was seen that α-pinene consumption could be described by a first-order kinetics.Conference Object Citation - WoS: 2Citation - Scopus: 2Investigation of the Permeability of Pure Gases in Sol-Gel Derived Al 2o 3 Membrane(Trans Tech Publications, 2004) Topuz, Berna; Çiftçioğlu, Muhsin; Özkan, FehimeThe preparation, characterization and pure gas permeation of sol-gel derived alumina membranes were investigated in this work. The effects of acid concentration/type and water content on the particle size in the sols and pore size distributions of the unsupported membrane were investigated by N 2 adsorption/desorption isotherms and Dynamic Light Scattering. Increasing the H +/Al 3+ mole ratio from 0.1 to 0.25 caused the hydrodynamic sol particle size and BJH pore size to decrease from 65 to 30 nm and 3.6 to 2.9 nm, respectively. The pore size increased from 2.8 nm to 3 nm upon increasing the calcination temperature from 500 to 600°C. Unsupported membranes were heat treated in the 200 to 1200 °C range for the characterization of the phase structure. Pinhole and crack free alumina membranes about 3 μm (2-layer) in thickness was observed from the SEM pictures with insignificant infiltration. The CO 2 permeability through the double layer γ-Al 2O 3 membrane calcined at 600 °C was 2.25*10 -7 mol/m 2.s.Pa, and had a slight pressure dependence indicating Knudsen Diffusion and Laminar Flow being the effective transport mechanisms. Upon the calcination of a similar 2-layer alumina membrane at 500°C, the CO 2 permeability decreased to 1.51 *10 -8 mol/m 2.s.Pa. without pressure dependence.Conference Object Citation - Scopus: 1Effects of Processing on the Properties and Permeability of Pure Gases Through Sol-Gel Silica Membranes(Trans Tech Publications, 2004) Topuz, Berna; Çiftçioğlu, Muhsin; Özkan, FehimeN2, O2 and CO2 pure gas permeation through sol-gel derived silica membranes were determined and the effects of processing parameters on the microstructure of the membrane was investigated. Silica sols were prepared in an alcoholic solution by hydrolysis and condensation of TEOS as a function of acid content. The thickness of the silica membranes was determined to be about 2μm and significant infiltration into the support was observed from the SEM pictures. The supported membranes were heat treated in the 50-400°C. The N2 permeabilities of silica membranes varied in the 2.2*10-10-2.7*10-8 mol/m2.s.Pa range for single layer membranes dipped for 10s. in the sol. The CO2 permeability of these membranes varied in the 1.2*10-9-6.95 *10-8 mol/m2.s.Pa range. The sols became viscous and gelled at 50°C in 16 hours. The O2 permeability increased with aging time. The optimum dipping time during processing was determined to be 10 seconds. The increase in the acid content of the sols were observed to increase permeabilities of the membranes significantly.Article Citation - WoS: 8Citation - Scopus: 8Water Vapour Adsorption on Organic and Inorganic Polymers(Springer Verlag, 2003) Balköse, Devrim; Özkan, Fehime; Ulutan, Sevgi; Ülkü, SemraWater vapour adsorption on polymers affects their processing behaviour and useful properties. Water vapour adsorption on organic polymers, silk, Nylon 6 fibres in undrawn and permanent set forms, polyester micro fibres, plasticised PVC films with 60 phr dioctylphthalate (OOP) and inorganic polymer sepiolite particles were investigated in this study. The materials were examined using the BET equation. The surface areas of silk, cast Nylon 6 and muss Nylon 6 were determined as 108, 46 and 23 m2 g-1, respectively. Sepiolite did not fit BET equation. Polyester and PVC adsorbed very small amounts of moisture.Article Citation - WoS: 47Citation - Scopus: 52Isomerization of ?-Pinene Over Ion-Exchanged Natural Zeolites(Elsevier Ltd., 2003) Özkan, Fehime; Gündüz, Gönül; Akpolat, Oğuz; Beşün, Nurgün; Murzin, Dmitry Yu.Catalysts prepared by ion exchange of clinoptilolite-based natural zeolite tuffs with NH4 +, Ba2+ and Pb2+ were investigated in the isomerization reaction of α-pinene at atmospheric pressure under nitrogen flow. Activity and selectivity to mono-, bi- and tricyclic products were correlated with acidity strength.Article Citation - WoS: 39Citation - Scopus: 46Alpha-Pinene Isomerization on Acid-Treated Clays(Elsevier Ltd., 2002) Beşün, Nurgün; Özkan, Fehime; Gündüz, GönülLiquid phase isomerization of α-pinene was studied over a number of differently pre-treated montmorillonite clays. The effects of the acid pre-treatment parameters (acid-to-clay ratio (A/C), water-to-acid ratio (W/A), temperature and pre-treatment time) on the product distribution were investigated. It was observed that the pre-treatment with acid improved the catalytic activity of that catalyst which was activated at 200 °C for 4 h at A/C ratios between 0.2 and 0.4. Alpha-pinene consumption was very small over the catalysts prepared with an A/C ratio of 0.8. Characterization studies that were done by nitrogen and water vapor adsorption experiments and by IR measurements showed that catalysts with high differential pore volumes for pores around 2 nm and homogenous mesopore distributions and with low dealumination degrees were good catalysts for the production of camphene. Catalysts having heterogeneous mesoporosity were found to be the preferable ones for limonene production.Article Citation - WoS: 47Citation - Scopus: 49Characterization of Hollow Chemical Garden Fibers From Metal Salts and Water Glass(Springer Verlag, 2002) Balköse, Devrim; Özkan, Fehime; Köktürk, Uğur; Ulutan, Sevgi; Ülkü, Semra; Nişli, GürelHollow fibers formed from water glass and metal salts of IIA(Ca), VIIB(Fe, Co, Ni) and IB(Cu) groups were characterised in this study. Fragile fibres obtained herein broke down into small pieces during isolation and drying. Quantitative information about morphology, chemical composition and surface structure of the fibres were obtained. The diameter and wall thickness of the fibers were around 50 μ and 3 μ. respectively. They had particulate inner and smooth outer surfaces. Fibers had variable composition with metal (II) oxide/SiO2 ratio in the range 0.31 to 1.02. While group VIIB metal (II) fibres were amorphous, group IIA and IB metal (II) fibers were partially crystalline All the fibres had pores both in micro pore and meso pore region. The B.E.T. surface area fron N2 adsorption data was in the range of 10-249 m3 g-1 and 8-176 m2 g-1 from Langmuir an B.E.T. models respectively.Article Citation - WoS: 13Citation - Scopus: 15A Study of Adsorption of Water Vapour on Wool Under Static and Dynamic Conditions(Springer Verlag, 1998) Ülkü, Semra; Balköse, Devrim; Çağa, Tayfun; Özkan, Fehime; Ulutan, SevgiAdsorption of water vapour on wool provides not only textile comfort, but also convenience in transportation due to increase in its bulk density. The adsorption and desorption isotherms of water vapour for wool were determined by both volumetric technique using a Coulter Omnisorp 100CX instrument and gravimetric method employing a Cahn 2000 electronic microbalance. Adsorption isotherm fitting to B.E.T. model and hysteresis on desorption was observed. The average effective diffusion coefficient of water in wool was found to be 8.4 × 10-14 m2 s-1 at 25°C from gravimetric data. The effects of packing height and air velocity on the breakthrough curves were also investigated in the wool packed columns. For pseudo first order model, k values changing between 0.33 × 10-6 -69 × 10-6 s-1 was obtained for 2.2-6.4 cm s-1 air velocity and 0.05-0.20 m packing height ranges.