Chemical Engineering / Kimya Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/14
Browse
23 results
Search Results
Article Citation - WoS: 4Citation - Scopus: 5Quantification of Peg40st Squeeze Out From Dspc/Peg40st Monolayers at Higher Molar Ratios(Elsevier Ltd., 2018) Kılıç, SevgiMixtures of 1,2 Distearoyl-sn-glycero-3-phosphocholine (DSPC) and polyoxyethylene-40-stearate (PEG40St) were prepared at different molar ratios and their miscibility were investigated using Langmuir isotherms. Pure DSPC monolayer exhibited a liquid-condensed (LC) phase whereas PEG40St monolayer exhibited liquid-expanded (LE) phase at the air-water interface at 22 ± 2 °C. At the collapse pressure of 33 mN/m, the PEG40St mean molecular area was calculated to be 28 Å2/molecule for 9:1 composition and 50 Å2/molecule for 5:5 composition, showing an increasing trend with the emulsifier content. A quantification method was developed to estimate the squeeze out amount of PEG40St from Langmuir isotherms of the DSPC/PEG40St mixtures at different molar ratios. Almost 93%, 82%, and 53% of PEG40St displaced for the 9:1, 7:3, and 5:5 mixtures, respectively, at the end of the first collapse plateau and showed a decreasing trend with the PEG40St content. Remaining PEG40St squeezed out at the end of the second collapse plateau, where 20% of PEG40St still contained within the 5:5 composition. It was concluded that increasing PEG40St content would be advantageous to design more stable lipid based microbubbles.Article Citation - WoS: 63Citation - Scopus: 70Laos Behavior of the Two Main Gluten Fractions: Gliadin and Glutenin(Elsevier Ltd., 2017) Yazar, Gamze; Çağlar Duvarcı, Özlem; Tavman, Şebnem; Kokini, Jozef L.Crude gliadin and glutenin fractions were studied using Large Amplitude Oscillatory measurements. LAOS measurements were carried out at three different frequencies (20, 10, 1 rad/sec) between the strain values of 0.01–200%. The beginning of non-linearity for glutenin occurred at ∼2.5%, while an initial region of strain hardening was observed for gliadin (2.5–10%) at 1 rad/sec frequency and up to 15% at the higher frequencies applied. Lissajous curves showed in the elastic analysis of both fractions glutenin was more elastically dominated since Lissajous curves were narrower, while for gliadin the ellipses were much broader suggesting more fluid-like behavior and each ellipse depended on the magnitude of frequency. Decreasing frequency increased the viscous behavior of both glutenin and gliadin in the non-linear region, but the change in gliadin was much more pronounced. Gliadin molecules only display intramolecular disulfide bonds creating a great deal of mobility whereas for glutenin molecules, which contain both intermolecular and intramolecular disulfide bonds, the strong network structure formed by this molecular arrangement results in very pronounced strain stiffening.Article Citation - WoS: 16Citation - Scopus: 19Designing of Spherical Chitosan Nano-Shells With Micellar Cores for Solvation and Safeguarded Delivery of Strongly Lipophilic Drugs(Elsevier Ltd., 2017) Cihan, Esra; Polat, Mehmet; Polat, HürriyetChitosan is a very effective biopolymer for drug delivery purposes due to its biocompatibility, positive charge and exceptionally pH sensitive degradability behavior in an aqueous medium. Nevertheless, its inability for dissolving lipophilic drug active material and the difficulties in controlling the size and shape of the synthesized particles in nanometer range are critical drawbacks in its effective use. In this study, a synthesis procedure which addresses both issues simultaneously is presented. The procedure is based on initial dissolution of lipophilic drug molecules within the hydrophobic cores of the micelles of a bio-compatible block-copolymer by ionic gelation and subsequent formation of a chitosan shell by polymerization around the micellar structures. Well-formed, hollow and perfectly spherical chitosan particles (nano-shells) in the 30–300 nm size range could be successfully manufactured. Characterization by STEM, TEM, AFM, FTIR and DLS, DLS-LDV techniques showed clearly that the drug was successfully incorporated into the chitosan structure. It was demonstrated that the particles enveloped the micelle(s) of a Pluronic copolymer (P-123) whose hydrophobic cores contained a strongly hydrophobic drug Probucol. The chitosan nano-shells are expected to act as an agent protecting the integrity of the drug-loaded micelles in the body fluid while providing a pH sensitive release medium. The drug uptake by the chitosan particles was very high. A very sharp increase in the amount of the drug released with a slight change in the acidity of the medium was an indication of the potential of the manufactured chitosan nano-shells as pH sensitive, target specific delivery vehicles for drug release.Article Citation - WoS: 41Citation - Scopus: 42Non-Linear Rheological Behavior of Gluten-Free Flour Doughs and Correlations of Laos Parameters With Gluten-Free Bread Properties(Elsevier Ltd., 2017) Yazar, Gamze; Çağlar Duvarcı, Özlem; Tavman, Şebnem; Kokini, Jozef L.Predicting loaf volume development of gluten free baked products to have similar properties to wheat products remains a challenge and there is no good marker for loaf volume. Large Amplitude Oscillatory Shear (LAOS) flow experiments and baking tests were conducted on rice, buckwheat, quinoa, and soy flour doughs to understand if there is any correlation between the non-linear rheological properties and loaf volume. The challenging water absorption capacities were determined by matching the η* vs. frequency data of the gluten free flours with that of the soft wheat flour dough with moisture content at 500 BU. 110%, 90%, 85%, and 160% water levels were found as optimal for rice, buckwheat, quinoa, and soy flour, respectively. The comparison of elastic Lissajous-Bowditch curves showed that the stronger non-linearities were seen at low frequencies and the wider the loop, the weaker the structure and the more structural breakdown with an order of soft wheat, soy, buckwheat, quinoa and rice flour doughs. Secondary loops have been observed in viscous Lissajous-Bowditch curves which are related to the strong non-linearities in elastic stress. The distributions of elastic and viscous LAOS parameters showed that soy dough has the closest rheological performance to wheat dough among other dough samples, which has the highest protein content. GL ′ and GM ′ values at 10 rad/s and 200% strain showed the best correlation among all LAOS parameters with the loaf volume. The strain stiffening/softening property e3/e1 complemented the mechanistic explanations which were offered using GL ′ and GM ′ values.Article Citation - WoS: 23Citation - Scopus: 31Nano-Caco3 Synthesis by Jet Flow(Elsevier Ltd., 2017) Ülkeryıldız, Eda; Kılıç, Sevgi; Özdemir, EkremA new methodology was introduced to produce hollow nano calcite particles in homogenous size distribution without aggregation. The design consisted of a jet flow system in which the crystallization region was separated from the stabilization region. The newly produced nano CaCO3 particles of about 140 nm were removed from the crystallization region as quickly as possible into the stabilization region before aggregation or crystal growth. In the stages of crystallization, the particles started to dissolve from their edges which opened-up the pores inside the particles. At the late stages of crystallization, the open pores closed. These particles were stable in Ca(OH)2 solution and no aggregation was detected. Different particles with different morphologies can be produced by adjusting the stages in the crystallization.Article Citation - WoS: 30Citation - Scopus: 31Esterification of Cetyl Alcohol With Palmitic Acid Over Wo3/Zr-sba-15 and Zr-Sba Catalysts(Elsevier Ltd., 2016) Mutlu, Nahide Nuran; Yılmaz, SelahattinTungsten loaded and Zr incorporated SBA-15 catalysts (WO3/Zr-SBA-15 and Zr-SBA-15) were developed for esterification of cetyl alcohol and palmitic acid. The influence of the Zr content, tungsten loading amount, calcination temperature, feed composition and catalyst amount has been studied. Higher tungsten loading decreased the acidity due to formation of WO3 crystals whereas calcination temperature enhanced the acidity by favoring the dispersion of WOx species. Activities of the catalyst changed depending on their amount of Brønsted sites and total number of acid sites. Zr-SBA-15 catalyst which had the highest amount of Brønsted acid sites gave maximum cetyl palmitate yield (63.1%). This catalyst retained its activity up to 3 reuse cycles without significant loss of activity.Article Citation - WoS: 13Citation - Scopus: 15Ancillary Effects of Surfactants on Filtration of Low Molecular Weight Contaminants Through Cellulose Nitrate Membrane Filters(Elsevier Ltd., 2016) Olcay, Aybike Nil; Polat, Mehmet; Polat, HürriyetRemoval of contaminants with low molecular weight (<800 Dalton) requires the use of advanced separation techniques such as ultrafiltration (UF) or micellar enhanced ultrafiltration (MEUF). However, surface active agents invariably co-exist in waste waters along with these contaminants or they may be added intentionally as part of the separation process as in the case of MEUF. Though it is quite likely that both the filter medium and the contaminants would interact with the surfactant molecules or their micelles, there is not sufficient emphasis in the literature on the concomitant aspects of such interactions.The ancillary effects created by anionic (sodium dodecyl sulfate, SDS), cationic (hexadecyltrimethyl ammonium bromide, CTAB) and non-ionic (ethoxylated octylphenol, TX-100) surfactants on the mechanism and efficiency of the filtration process were investigated in this study. Methylene blue (MB) and cellulose nitrate membrane (CNM) filters were employed as model retentate and the separation medium. A combination of surface tension, contact angle and charge measurements demonstrated that the addition of surfactants had a remarkable effect on the filtration outcome. The effect depended on both the type and concentration of the surfactant and was manifested mainly through the creation of MB-surfactant entities which acted differently than the MB alone; but more importantly, through the interactions of the surfactant molecules/micelles and the MB-surfactant pairs with the separation membrane.Article Citation - WoS: 28Citation - Scopus: 31The Effects of Catalyst Pretreatment, Growth Atmosphere and Temperature on Carbon Nanotube Synthesis Using Co-mo/Mgo Catalyst(Elsevier Ltd., 2015) İnce Yardımcı, Atike; Yılmaz, Selahattin; Selamet, YusufThe growth of high quality and high yield carbon nanotubes (CNTs) by catalytic chemical vapor deposition (CVD) of CH4 over Co-Mo/MgO catalyst was investigated for different growth temperatures and H2 flow rates. It was observed that CNT yield decreased with the H2 flow rate, however, quality increased with increasing H2 flow rate. CNT yield increased for the temperatures 850-950 °C but dropped significantly above 950 °C. In this study, the highest yield of 1526% was obtained at the growth temperature of 950 °C. The optimum H2 flow rate was 200 sccm; this rate gave both high graphitization and high yield of product. Various CNT growth atmospheres including Ar, H2 and the mixture of both gases were also analyzed and it was observed that the highest quality CNTs were obtained for both pretreatment and growth carried out with H2. This gave a high yield of 292%. On the other hand, CNT growth carried out under Ar atmosphere gave higher CNT yield of 368%, however, the CNTs grown with Ar were more defective and had larger diameters. Prime novelty statement We demonstrate a sorbitol added catalysis synthesis method and importance of the ideal growth conditions to improve high quality single walled carbon nanotube yield up to 1500%.Article Citation - WoS: 14Citation - Scopus: 25Kinetic and Equilibrium Studies of Adsorption of Ss-Glucuronidase by Clinoptilolite-Rich Minerals(Elsevier Ltd., 2015) Demirbüker Kavak, Dilek; Ülkü, SemraThe adsorption of the bacterial β-glucuronidase (GUS) enzyme, which is thought to be responsible for the production of reactive metabolites related to some diseases and cancer development, by clinoptilolite-rich mineral was investigated. Batch experiments were performed to analyze of the effects of the clinoptilolite amount and particle size, initial GUS concentration, shaking rate, pH and temperature on the adsorption equilibrium and kinetics. Adsorption equilibrium data were interpreted in terms of Langmuir and Freundlich isotherms; and they were well represented by the Langmuir isotherm model. The percentage of GUS removal by the clinoptilolite-rich mineral was changed in the range of 9.4-54.4% depending on its initial concentration. The kinetic data were analyzed using external film diffusion, intraparticle diffusion, pseudo-first-order and pseudo-second-order models and both external film and intraparticle diffusion appeared to be effective in GUS adsorption. Thermodynamic studies indicated that GUS adsorption is exothermic, physical and spontaneous at the temperatures investigated (288-310 K)Article Citation - WoS: 9Citation - Scopus: 8Measurement of Ternary Polymer/Solvent Equilibrium Data by Vapor-Phase Infrared Spectroscopy(Elsevier Ltd., 2009) Yürekli, Yılmaz; Alsoy Altınkaya, SacideVapor-liquid equilibrium (VLE) data for binary toluene/PVAC, methanol/PVAC and ternary toluene/methanol/PVAC systems have been measured at 100 °C by using vapor-phase infrared spectroscopy. Binary data have been compared with literature data measured by different experimental techniques and agreement between our measurements and others was found to be good. The ternary VLE data indicate that the solubility of methanol in PVAC is not influenced by the presence of toluene, while the solubility of toluene is lowered due to presence of methanol. To predict ternary VLE data, the Entropic free volume and Kannan free volume models and the Flory-Huggins theory were used. The predictive abilities of Flory-Huggins theory and the Kannan free volume model are similar and better than that of the Entropic free volume model.
- «
- 1 (current)
- 2
- 3
- »