Chemical Engineering / Kimya Mühendisliği
Permanent URI for this collectionhttps://hdl.handle.net/11147/14
Browse
4 results
Search Results
Now showing 1 - 4 of 4
Article Citation - WoS: 17Citation - Scopus: 19Heavy Naphtha Upgrading by Catalytic Reforming Over Novel Bi-Functional Zeolite Catalyst(Springer, 2018) Ahmedzeki, Nada S.; Al-Tabbakh, Ban A.; Antwan, Maher B.; Yılmaz, SelahattinNaphtha catalytic reforming process using bimetallic platinum and titanium loaded on nano synthesized HY zeolite was investigated for the product octane number enhancement. The activity of five samples of the prepared catalyst with different bimetallic loading of 0.13, 0.25 wt% Pt and 0.75, 1, 2.2 wt% Ti were investigated for Iraqi heavy naphtha catalytic reforming at the temperature range of 490, 500 and 510 degrees C and pressure of 10 bar in a packed bed pilot plant reactor. The best result of the research octane number was 84 for reformate product using the sample of 0.13% Pt-0.75% Ti%/HY zeolite at temperature 510 degrees C and 10 bar achieving 47% increase. All samples of the prepared catalyst showed a good stability during the operation at severe conditions and the maximum carbon content was about 9% due to the deposition of coke precursor on the catalyst surface. The reformate yield was investigated for all catalyst samples under 10 and 20 bars and the same range of temperature and ranged from 89 to 94%. These results are encouraging for future possible replacement of the conventional catalyst by the local synthetic zeolite. Octane number was correlated on the basis of constituent's boiling points. The maximum absolute error between the experimental and predicted octane number was about 3 and 5% using 10 and 20 bar respectively.Article Effective Synthesis of Cetyl Palmitate Over Co-Precipitated Wo3-Zro2 Catalysts(Springer Verlag, 2018) Mutlu, Vahide N.; Yılmaz, SelahattinThis study is focused on the development of solid acid catalysts for the synthesis of long chain fatty acids. A series of WO3-ZrO2 catalysts were prepared by co-precipitation method and tested in the synthesis of cetyl palmitate. The effect of WO3 loading (10, 15, and 20 wt% WO3) and calcination temperature (700 and 800 degrees C) on the catalyst properties and activity was investigated. XRD and Raman analysis confirmed that WO3 loading stabilized the tetragonal zirconia phase. Higher calcination temperature enhanced the acidities of the catalysts. WO3-ZrO2 catalysts were found to be very efficient for the synthesis of cetyl palmitate with high selectivity. These catalysts were tested for different reaction temperatures (135 and 162 degrees C), feed composition and catalyst amounts. The highest cetyl palmitate yield (98.4%) was obtained over the catalyst calcined at 800 degrees C with 15 wt% WO3, which had the highest total acidity. The catalysts preserved their activities up to three reuse.Article Citation - WoS: 18Citation - Scopus: 17Cnt Incorporated Polyacrilonitrile/Polypyrrole Nanofibers as Keratinocytes Scaffold(Trans Tech Publications, 2019) İnce Yardımcı, Atike; Aypek, Hande; Öztürk, Özgür; Yılmaz, Selahattin; Özçivici, Engin; Meşe, Gülistan; Selamet, YusufPolypyrrole (PPy) is an attractive scaffold material for tissue engineering with its non-toxic and electrically conductive properties. There has not been enough information about PPy usage in skin tissue engineering. The aim of this study is to investigate biocompatibility of polyacrilonitrile (PAN)/PPy nanofibrous scaffold for human keratinocytes. PAN/PPy bicomponent nanofibers were prepared by electrospinning, in various PPy concentrations and with carbon nanotube (CNT) incorporation. The average diameter of electrospun nanofibers decreased with increasing PPy concentration. Further, agglomerated CNTs caused beads and disordered parts on the surface of nanofibers. Biocompatibility of these PAN/PPy and PAN/PPy/CNT scaffolds were analyzed in vitro. Both scaffolds provided adhesion and proliferation of keratinocytes. Nanofiber diameter did not significantly influence the morphology of cells. However, with increasing number of cells, cells stayed among nanofibers and this affected their shape and size. In this study, we demonstrated that PAN/PPy and PAN/PPy/CNT scaffolds enabled the growth of keratinocytes, showing their biocompatibility.Article Citation - WoS: 11Citation - Scopus: 11Effect of Different Acidity Modifications on the Activity and Selectivity on H-Zsm5 Zeolites in N-Butene Isomerization(Springer Verlag, 2014) Kılıç, Emre; Yılmaz, SelahattinH-ZSM-5 was modified by silylation [tetraethylorthosilicate (TEOS) and triaminopropyltriethoxysilane], alkali (NaOH), acid (HCl) and ammoniumhexafluorosilicate (AHFS) treatments. The parent and modified zeolite forms were tested in n-butene isomerization. Modifications affected total acidities, the strength of the acid sites, pore sizes and surface areas of the H-ZSM-5 differently. The modifications decreased the conversion obtained by the parent catalyst. TEOS and alkali modifications did not promote formation of isobutene. Pre-alkali treatment before acid treatment increased selectivity to isobutene from 56.0 to 66.7 %, while conversion changed a little, it dropped from 52 to 50 %. AHFS modification provided the highest enhancement in selectivity to isobutene (87.5 %) for which n-butene conversion was dropped by about 10 % compared to H-ZSM-5. This was attributed to a slight modification of the pore size and to the reduction in strong and weak acid sites and generation of new Lewis acid sites.