Chemistry / Kimya
Permanent URI for this collectionhttps://hdl.handle.net/11147/4072
Browse
8 results
Search Results
Other Corrigendum To “modification of a Montmorillonite–illite Clay Using Alkaline Hydrothermal Treatment and Its Application for the Removal of Aqueous Cs+ Ions” [j. Colloid Interface Sci. 295 (2006) 303–309](Elsevier Ltd., 2006) Öztop, Bahar; Shahwan, TalalUnfortunately, we noticed that Ref. [8], which was cited three times in our article, was mistakenly not cited also in the experimental part as the reference on which we based our hydrothermal treatment process. In light of this, the first paragraph of the experimental section (pages 303 and 304) should read...Article Citation - WoS: 33Citation - Scopus: 33Modification of a Montmorillonite-Illite Clay Using Alkaline Hydrothermal Treatment and Its Application for the Removal of Aqueous Cs+ Ions(Elsevier Ltd., 2006) Öztop, Bahar; Shahwan, TalalA montmorillonite-illite clay was modified using alkaline hydrothermal treatment (reflux method) and applied to the removal of aqueous Cs+ ions. The alkaline solutions were prepared by dissolving NaOH in seawater and in distilled water, and the effect of the two alkaline media on the sorption capacities of the modified clay was discussed. The modified materials were characterized using XRD, SEM/EDS, and FTIR. As a result of the modification, the original mineral was partially transformed into a zeolitic material with spherical morphology. The results showed that the modification improved the Cs+ uptake capacity of the starting clay, with the clay modified in distilled water medium demonstrating higher sorption capacity. The sorption data were adequately described using the Freundlich and Dubinin-Radushkevich isotherm models.Article Citation - WoS: 19Citation - Scopus: 21Kinetic and Thermodynamic Investigations of Strontium Ions Retention by Natural Kaolinite and Clinoptilolite Minerals(Walter De Gruyter Gmbh, 2005) Akar, Dilek; Shahwan, Talal; Eroğlu, Ahmet EminThe current study was devoted to the determination of various thermodynamic and kinetic parameters resulting from the fixation of Sr2+ by natural samples of kaolinite and clinoptilolite minerals. The sorption process followed pseudo second order kinetics, with faster sorption on kaolinite compared to clinoptilolite, where the uptake is affected by intraparticle diffusion. Freundlich and Dubinin-Radushkevich isotherm models described the data more adequately than Langmuir model, and clinoptilolite showed a higher strontium sorption capacity than kaolinite. Thermodynamically, the activation energy of Sr2+ sorption by kaolinite and clinoptilolite were respectively, -8.5 and -18.4 kJ/mol. The sorption process on both minerals was spontaneous and endothermic at all the studied concentrations, with ΔH° being 11.3 and 9.8 kJ/mol, for sorption on kaolinite and clinoptilolite, respectively. The findings of this study were compared with those of an earlier study on the uptake of Cs+ by the same minerals.Article Citation - WoS: 109Citation - Scopus: 119Synthesis of Amidoximated Polyacrylonitrile Fibers and Its Application for Sorption of Aqueous Uranyl Ions Under Continuous Flow(Elsevier Ltd., 2012) Horzum Polat, Nesrin; Shahwan, Talal; Parlak, Onur; Demir, Mustafa MuammerThis study reports a feasible method for the removal of radioactive U(VI) ions from aqueous systems via column sorption under continuous flow. Electrospun polyacrylonitrile (PAN) fibers were used as sorbent materials in a homemade minicolumn. The nitrile groups on the fibers' surface were modified to amidoxime groups using hydroxylamine hydrochloride. Surface modification was observed to enhance the sorption capacity of PAN fibers toward uranium ions by more than 4-fold by virtue of the chelating ability of the amidoxime groups. The experiments investigated the effect of pH, initial concentration, and repetitive loading on the sorption properties of amidoximated PAN fibers. Based on the overall results, the surface-modified fibers seem to be a suitable potential sorbent material for applications in environmental cleanup, particularly for nuclear plants.Article Citation - WoS: 2Citation - Scopus: 4Tof-Sims Depth Profiling Analysis of the Uptake of Ba2+ and Co2+ Ions by Natural Kaolinite Clay(Elsevier Ltd., 2004) Shahwan, Talal; Erten, Hasan N.; Black, Leon; Allen, Geoffrey CharlesThe sorption behavior of Ba2+ and Co2+ ions on a natural clay sample rich in kaolinite was studied using time-of-flight secondary ion mass spectrometry (ToF-SIMS). Depth profiling at 10-Å steps was performed up to a 70-Å matrix depth of the clay prior to and following sorption. The results showed that Co2+ is sorbed in slightly larger quantities than Ba2+, with significant numbers of ions fixed on the outermost surface of the clay. Depletion of the ions K+, Mg 2+, and Ca2+ from the clay lattice was observed to accompany enrichment with Co2+ and Ba2+ ions. The data obtained using X-ray powder diffraction (XRPD) and scanning electron microscopy (SEM) indicated insignificant structural and morphological changes in the lattice of the clay upon sorption of both Ba2+ and Co2+ ions. Analysis using energy dispersive X-ray spectroscopy (EDS) showed that the average atomic percentage (±S.D.) of Ba and Co on kaolinite surface were 0.49±0.11 and 0.61±0.19, respectively, indicating a limited uptake capacity of natural kaolinite for both ions.Article Citation - WoS: 14Citation - Scopus: 15Chitosan-Immobilized Pumice for the Removal of As(v) From Waters(Springer Verlag, 2014) Turan, Dilek; Kocahakimoğlu, Cemre; Boyacı, Ezel; Sofuoğlu, Sait Cemil; Eroğlu, Ahmet EminA novel sorbent, chitosan-immobilized pumice, has been prepared for the sorption of As(V) from waters prior to its determination by hydride generation atomic absorption spectrometry. The success of the immobilization has been checked with such characterization techniques as scanning electron microscopy, thermal gravimetric analysis, and elemental analysis. Points of zero charge of the sorbents were determined with potentiometric mass titration. Batch-type equilibration studies have shown that the novel sorbent can be employed at a wide pH range resulting in quantitative sorption (>90 %) at pH 3.0-7.0 and greater than 70 % sorption at pH >8.0. These results demonstrate the advantage of immobilizing chitosan onto pumice, because, under the same conditions, pumice displays <20 % sorption toward As(V), whereas chitosan gives approximately 90%sorption only at pH 3.0. The validity of the method was verified through the analysis of ultrapure, bottled drinking, and tap water samples spiked with arsenate; the respective sorption percentages of 93.2 (±0.7), 89.0 (±1.0), and 80.9 (±1.3) were obtained by batch-type equilibration. Arsenic sorption was also examined in the presence of common interfering ions resulting in competing effects of PO3- 4 and NO- 3on As(V) adsorption.Article Citation - WoS: 50Citation - Scopus: 53Physicochemical Characterization of the Retardation of Aqueous Cs+ Ions by Natural Kaolinite and Clinoptilolite Minerals(Elsevier Ltd., 2005) Shahwan, Talal; Akar, Dilek; Eroğlu, Ahmet EminThe aim of this study was to carry out kinetic, thermodynamic, and surface characterization of the sorption of Cs+ ions on natural minerals of kaolinite and clinoptilolite. The results showed that sorption followed pseudo-second-order kinetics. The activation energies were 9.5 and 13.9 kJ/mol for Cs+ sorption on kaolinite and clinoptilolite, respectively. Experiments performed at four different initial concentrations of the ion revealed that the percentage sorption of Cs+ on clinoptilolite ranged from 90 to 95, compared to 28 to 40 for the kaolinite case. At the end of a 1 week period, the percentage of Cs+ desorption from clinoptilolite did not exceed 7%, while it amounted to more than 30% in kaolinite, indicating more stable fixation by clinoptilolite. The sorption data were best described using Freundlich and D–R isotherm models. Sorption showed spontaneous and exothermic behavior on both minerals, with ΔH0 being −6.3 and −11.4 kJ/mol for Cs+ uptake by kaolinite and clinoptilolite, respectively. Expanding the kaolinite interlayer space from 0.71 to 1.12 nm using DMSO intercalation, did not yield a significant enhancement in the sorption capacity of kaolinite, indicating that the surface and edge sites of the clay are more energetically favored. EDS mapping and elemental analysis of the surface of kaolinite and clinoptilolite revealed more intense signals on the surface of the latter with an even distribution of sorbed Cs+ onto the surfaces of both minerals.Article Citation - WoS: 36Citation - Scopus: 35Sorption of As(v) From Waters Using Chitosan and Chitosan-Immobilized Sodium Silicate Prior To Atomic Spectrometric Determination(Elsevier Ltd., 2010) Boyacı, Ezel; Eroğlu, Ahmet Emin; Shahwan, TalalA natural biosorbent containing amine functional groups, chitosan, and a novel sorbent, chitosan-immobilized sodium silicate, were prepared and utilized for the selective sorption of As(V) from waters prior to its determination by atomic spectrometric techniques, namely, hydride generation atomic absorption spectrometry (HGAAS) and inductively coupled plasma mass spectrometry (ICP-MS). Chitosan was synthesized from chitin and sodium silicate was used as the immobilization matrix due to its straightforward synthesis. Through sequential sorption studies, it was shown that chitosan-immobilized sodium silicate has exhibited a better chemical stability than the chitosan itself which demonstrates the advantage of immobilization method. Both chitosan and chitosan-immobilized sodium silicate were shown to selectively adsorb As(V), arsenate, from waters at pH 3.0 at which neither chitin nor sodium silicate displayed any sorption towards As(V). The sorption of arsenate by chitosan is supposed to have electrostatic nature since pH of 3.0 is both the point at which the amino groups in chitosan are protonated and also the predominant form of As(V) is H2AsO4−. A pre-oxidation step is required if both As(III) and As(V) are to be determined. Desorption from the sorbents was realized with 1.0% (w/v) l-cysteine prepared in a pH 3.0 solution adjusted with HCl. Among the possible interfering species tested, only Te(IV) and Sb(III) were shown to cause a decrease in the sorption capacity especially at high interferant concentrations. High concentrations of Sb(III) also resulted in gas phase interference during hydride generation.