Sürdürülebilir Yeşil Kampüs Koleksiyonu / Sustainable Green Campus Collection
Permanent URI for this collectionhttps://hdl.handle.net/11147/7755
Browse
9 results
Search Results
Article Citation - WoS: 62Citation - Scopus: 64Ultrasonic Nebulization-Sample Introduction System for Quantitative Analysis of Liquid Samples by Laser-Induced Breakdown Spectroscopy(Elsevier Ltd., 2012) Aras, Nadir; Ünal Yeşiller, Semira; Ateş Arıca, Dilek; Yalçın, ŞerifeIn this study, design and optimization studies of a sample introduction system based on ultrasonic nebulization of metal salts in aqueous environment for laser-induced breakdown spectroscopic detection were presented. The system consisted of an ultrasonic nebulizer connected to a tandem heater-condenser- membrane dryer unit that produces sub-micron size aerosols. Results indicate improvements in detection limits for some elements with the use of membrane dryer. Optimization studies were performed by systematical investigation of LIBS emission signal with respect to laser energy, carrier gas flow rate and detector timing parameters. Under optimized conditions, calibration graphs for Na, K, Mg, Ca, Cu, Al, Cr, Cd, Pb and Zn were constructed and detection limits were calculated. The applicability of the ultrasonic nebulization-LIBS system was tested on real water samples. This system establishes LIBS as an effective analytical tool for both qualitative and quantitative determination of metal aerosols in aqueous environments. This technique is sufficiently rapid to provide real-time monitoring of toxic metals.Article Citation - WoS: 23Citation - Scopus: 22Optimization of Chemical and Instrumental Parameters in Hydride Generation Laser-Induced Breakdown Spectrometry for the Determination of Arsenic, Antimony, Lead and Germanium in Aqueous Samples(Elsevier Ltd., 2013) Ünal Yeşiller, Semira; Yalçın, ŞerifeA laser induced breakdown spectrometry hyphenated with on-line continuous flow hydride generation sample introduction system, HG-LIBS, has been used for the determination of arsenic, antimony, lead and germanium in aqueous environments. Optimum chemical and instrumental parameters governing chemical hydride generation, laser plasma formation and detection were investigated for each element under argon and nitrogen atmosphere. Arsenic, antimony and germanium have presented strong enhancement in signal strength under argon atmosphere while lead has shown no sensitivity to ambient gas type. Detection limits of 1.1mgL-1, 1.0mgL-1, 1.3mgL-1 and 0.2mgL-1 were obtained for As, Sb, Pb and Ge, respectively. Up to 77 times enhancement in detection limit of Pb were obtained, compared to the result obtained from the direct analysis of liquids by LIBS. Applicability of the technique to real water samples was tested through spiking experiments and recoveries higher than 80% were obtained. Results demonstrate that, HG-LIBS approach is suitable for quantitative analysis of toxic elements and sufficiently fast for real time continuous monitoring in aqueous environments.Article Citation - WoS: 29Citation - Scopus: 38Encapsulating Fly Ash and Acidic Process Waste Water in Brick Structure(Elsevier Ltd., 2010) Köseoğlu, K.; Polat, Mehmet; Polat, HürriyetFly ash contains metals such as cadmium, iron, lead, aluminum and zinc in its structure in appreciable amounts. These metals can leach out into surface and ground waters if fly ash is not properly disposed of. A similar problem also exists for acidic process waste waters discharged by numerous industries. The purpose of this study was to utilize such wastes as additives in the production of construction quality bricks for the purpose of waste elimination. The bricks produced were subjected to flexural strength and water retention capacity tests along with heavy metal leaching experiments in order to determine the applicability of the procedure and the best possible recipes. This paper summarizes the results obtained in these tests along with the possible mechanisms involved in stabilizing the two wastes in the brick structure. © 2009 Elsevier B.V. All rights reserved.Conference Object Citation - WoS: 21Citation - Scopus: 21Development of a Continuous Flow Hydride Generation Laser-Induced Breakdown Spectroscopic System: Determination of Tin in Aqueous Environments(Elsevier Ltd., 2010) Ünal, Semira; Yalçın, ŞerifeThe design, construction and optimization studies of a continuous flow hydride generation laser-induced breakdown spectroscopic system, HG-LIBS, for the determination of tin in aqueous environments is presented. Optimization of the Laser Induced Breakdown Spectroscopy (LIBS) signal with respect to carrier gas flow rate, analyte, acid (HCl) and reductant (NaBH4) concentrations and flow rates was performed by using spectral emission intensity from the neutral Sn(I) line at 284.0 nm under atmospheric pressures. With flow rates of 5.0 mL/min for NaBH4 and 2.5 mL/min for HCl, optimum NaBH4 and HCl concentrations were determined as 2.0% (w/v) and 1.0% (v/v), respectively. The hydride generation efficiency of the system was tested for tin hydride, stannane (SnH4), by inductively coupled plasma mass spectrometer (ICP-MS). It was found that higher than 99% of the analyte was released into the gaseous phase. Upon optimization, the minimum detectable Sn concentration was found as 0.3 mg/L in water samples. That corresponds to more than two orders of increase in sensitivity compared to methods that employ common sample introduction techniques in liquids analysis by LIBS. Over 90% recoveries were obtained from spiking experiments with river, tap and drinking water samples. Results illustrate potential use of the continuous flow HG-LIBS system for monitoring of Sn concentrations in aqueous environments. © 2010 Elsevier Ltd. All rights reserved.Article Citation - WoS: 259Citation - Scopus: 284Heavy Metal Removal From Waste Waters by Ion Flotation(Elsevier Ltd., 2007) Polat, Hürriyet; Erdoğan, D.Flotation studies were carried out to investigate the removal of heavy metals such as copper (II), zinc (II), chromium (III) and silver (I) from waste waters. Various parameters such as pH, collector and frother concentrations and airflow rate were tested to determine the optimum flotation conditions. Sodium dodecyl sulfate and hexadecyltrimethyl ammonium bromide were used as collectors. Ethanol and methyl isobutyl carbinol (MIBC) were used as frothers. Metal removal reached about 74% under optimum conditions at low pH. At basic pH it became as high as 90%, probably due to the contribution from the flotation of metal precipitates.Article Citation - WoS: 211Citation - Scopus: 246A Radiotracer Study of the Adsorption Behavior of Aqueous Ba2+ Ions on Nanoparticles of Zero-Valent Iron(Elsevier Ltd., 2007) Çelebi, O.; Üzüm, Çağrı; Shahwan, Talal.; Erten, Hasan NRecently, iron nanoparticles are increasingly being tested as adsorbents for various types of organic and inorganic pollutants. In this study, nanoparticles of zero-valent iron (NZVI) synthesized under atmospheric conditions were employed for the removal of Ba2+ ions in a concentration range 10-3 to 10-6 M. Throughout the study, 133Ba was used as a tracer to study the effects of time, concentration, and temperature. The obtained data was analyzed using various kinetic models and adsorption isotherms. Pseudo-second-order kinetics and Dubinin-Radushkevich isotherm model provided the best correlation with the obtained data. Observed thermodynamic parameters showed that the process is exothermic and hence enthalpy-driven.Article Citation - WoS: 36Citation - Scopus: 40The Kinetics of Citral Hydrogenation Over Pd Supported on Clinoptilolite Rich Natural Zeolite(Elsevier Ltd., 2005) Yılmaz, Selahattin; Uçar, Şule; Artok, Levent; Güleç, HilalThe liquid phase hydrogenation of citral has been investigated over Pd (2.42%) supported on clinoptilolite rich natural zeolite catalyst for different reaction conditions. The zeolite support did not affect the active metal properties. This was attributed to the large size of Pd particles on the support. High selectivity (90%) to citronellal was obtained at complete conversion of citral. The catalytic activity increased with reaction temperature (80, 100, 120°C) following an Arrhenius behaviour, while selectivity remained constant for a given conversion. Selectivity to citronellal increased from 78 to 90% with increase in the amount of catalyst in the reaction solution (Citral/Pd mole ratio 293, 176 and 105). The spent catalyst regained its fresh activity and selectivity upon regeneration.Article Citation - WoS: 20Citation - Scopus: 23Electrostatic Charge on Spray Droplets of Aqueous Surfactant Solutions(Elsevier Ltd., 2000) Polat, Mehmet; Polat, Hürriyet; Chander, SubhashElectrostatic charges on individual spray droplets were measured using a refined form of the Millikan oil drop method. The measurement system consisted of three main sections; a droplet generation cell, a settling column and a charge measurement chamber. The trajectories required for calculation of charge were determined using a high-speed motion analyzer coupled to a long-focal-length microscope. Charges on droplets were manipulated by the addition of surface-active agents into the spray solution. Droplet charge was a function of the type and concentration of the surfactant added. For ionic surfactants, it showed a maximum at low surfactant concentrations, decreased with further surfactant addition and was constant after the CMC. The charge on cationic surfactants was always more than that observed with the anionic surfactants. Nonionic surfactants displayed a steady increase in droplet charge with increasing concentration. The charges were lower compared to the ionic surfactants. (C) 2000 Elsevier Science Ltd. Electrostatic charges on individual spray droplets were measured using a refined form of the Millikan oil drop method. The measurement system consisted of three main sections; a droplet generation cell, a settling column and a charge measurement chamber. The trajectories required for calculation of charge were determined using a high-speed motion analyzer coupled to a long-focal-length microscope. Charges on droplets were manipulated by the addition of surface-active agents into the spray solution. Droplet charge was a function of the type and concentration of the surfactant added. For ionic surfactants, it showed a maximum at low surfactant concentrations, decreased with further surfactant addition and was constant after the CMC. The charge on cationic surfactants was always more than that observed with the anionic surfactants. Nonionic surfactants displayed a steady increase in droplet charge with increasing concentration. The charges were lower compared to the ionic surfactants.Article Citation - WoS: 120Citation - Scopus: 127Equilibrium, Thermodynamic and Kinetic Studies for the Biosorption of Aqueous Lead(ii), Cadmium(ii) and Nickel(ii) Ions on Spirulina Platensis(Elsevier Ltd., 2008) Şeker, Ayşegül; Shahwan, Talal; Eroğlu, Ahmet Emin; Yılmaz, Sinan; Demirel, Zeliha; Conk Dalay, MeltemThe biosorption of lead(II), cadmium(II) and nickel(II) ions from aqueous solution by Spirulina platensis was studied as a function of time, concentration, temperature, repetitive reactivity, and ionic competition. The kinetic results obeyed well the pseudo second-order model. Freundlich, Dubinin Radushkevich and Temkin isotherm models were applied in describing the equilibrium partition of the ions. Freundlich isotherm was applied to describe the design of a single-stage batch sorption system. According to the thermodynamic parameters such as ΔG°, ΔH°and ΔS° calculated, the sorption process was endothermic and largely driven towards the products. Sorption activities in a three metal ion system were studied which indicated that there is a relative selectivity of the biosorbent towards Pb2+ ions. The measurements of the repetitive reusability of S. platensis indicated a large capacity towards the three metal ions.